|
I just got my Tactrix OP2 cable, downloaded/installed the EcuFlash BRZ Beta software, and connected my OP2 cable to the OBDII port of my FR-S and then to my laptop. OP2 does the multi-color light up thing when connected to the OBDII port, but my laptop cannot make a successful USB connection. I get an error that says that the device driver software was not successfully installed for the OpenPort 2.0.
I opened EcuFlash anyway to see if it would still read my car's ECU but there's a message on the lower right section of the interface that says: "No Vehicle Interace". I tried another computer in my house, followed the same setup procedures and am getting the same problem. Both computers are using Windows 7. Am I missing something obvious in my setup?
|