Quote:
Originally Posted by stockysnail
The two lines are 75mm stock pulley, not intercooled, 92oct gas on BRZedit tune @ Drift-Office Bob correct me if I'm wrong). The second is 70mm pulley, intercooled, 92oct gas on EcuTek. |
Both of them were with 92 Octane, ECUTek. The first one was our calibration pre-intercooler install. The second was a custom calibration from @
moto-mike, which I strongly recommend all who have the Innovate setup to at least get a calibration from.
I couldn't figure out why the setup was wigging out after the IC was installed and only after conferring with Mike @ Moto-East was it then I was told that it was an issue everyone was seeing (it's in the Innovate owner's thread) and that the stock MAP sensor was needed to fix this.
I had previously spent over 2 weeks trying to figure it out up to that point, so I have no wish to address this setup, ever again.
Cheers!
Bob @ Drift-Office, LLC