http://www.ft86club.com/forums/showp...&postcount=278
I posted my dyno result with JDL UEL + OFT stage2 in other thread.
1.dyno number was 191 ps ( from all stock 173 ).
its not super impressive, because my stage 1 result was 187.
but I use stock over & front pipe & I didn't manage FLKC with stage 2 map yet. so I'm satisfied with this.
2. but From 5300RPM to 6300 RPM , same torque as stage 1 result.
I was a bit disappointed at these range .
maybe it's due to OTS map is not 100% fit to my header.
( I don't know yet how to fine tune cam table )
or due to stock exhaust parts .
is there any possible way to improve these range?