|
John just sent that to me as well, but here it is
"The plug is to block off the resonator on the factory intake just before the throttle body on the bottom of the runner hose that attaches to the intake.
Installation is simple. Unbolt the passenger side engine mount and lift the engine up (leave the driver side mount attached) until the passenger side stud is about 1/4" above the surface of the subframe. Remove the factory manifold, then install your new manifold. The new one fits in, it just goes in a very specific way that you have to find by putting it in and moving it around.
Reuse the header gaskets that you took off with the factory manifold."
-Ryan @ Nameless
|