|
Well I LITERALLY just got the front lip in an unpackaged it. First thing I have to say is the packaging is very well done. It didn't come in a box but was basically wrapped in a bubble wrap, heavy duty cardboard armor and a whole lot of box tape. If it was going to get broken it would have to get run over by a truck. Also had "fragile" box tape around it to. Not that that usually helps but it was still there. So after i got it out of its armor shipping cage it looked very good as far as quality. The finish is very smooth and crisp. The edges are a tiny bit ruff and i do mean tiny bit. I will most likely take a bit of 300 grit sand paper to them when I test fit it. The ABS is quality thickness. Probably about 1/8 inch. There is 4 metal brackets on the underneath of the lip to attach it to the car which are riveted to the bumper and not screwed which shows more effort to me in quality.
It comes with the rubber edging where the lips fits up tight to the bumper of the car with is AWESOME. Leaves a very nice edge, also a very nice addition.
Then a few bolt for the license plate and a few screws for where it wraps around the inner wheel wells. It does not come with double sided tape so that will have to be added but not a big deal to me.
There was 1 small gouge in the front about 1/2 inch long but easily fixed before paint.
I can not speak for the fitment to the car just yet because my car is under a cover in my driveway with 6 inches of snow on it right now but as far as fist impressions and over all quality i am completely satisfied.
This bumper should is very good for the price and its defiantly not going to get that sag that occurs with poly kits.
|