OK, bit of an issue (or maybe it's not...you be the judge).
I had a beta version of the 93 Octane Stage 1 1.42 map installed on my car. I tested it yesterday and found that it did indeed have launch control...with the clutch in the revs would not pass 5600RPM...here is a capture of the parameters for that tune file:
I downloaded the new released 1.42 maps today and modified the 93 Octane Stage 1 and E85 EL Stage 2 maps to have a LC setting of 3600 (would equate to a 4000 RPM limiter) and FFS of 600 (so the RPMs would max at 7000 when using FFS). I saved these new files as "93 Octane v1.42 (FFS+LC).bin" and "E85 v1.42 (FFS+LC).bin" - NOTE - I did actually type ".bin" at the end of the file name when I was naming it - didn't seem to automatically attach that file type when I didn't the first time. Not sure if that matters or not.
Here are the two sets of parameters:
93 Octane v1.42 (unmodified)
93 Octane v1.42 (modified FFS and LC)
I loaded the modified map onto my car, but the launch control doesn't seem to be working. I pushed the clutch in and tried revving, but it just revved near redline, so I just let up. Tried that a couple of times, but got the same results. The car wasn't fully warmed up...not sure if that matters? Anyway, just wondering what, if anything, might be going on? It's not a huge deal, but I would like to know why it's not working now.
I didn't try the base released v1.42 map as an intermediate, but like I said, it was working with the beta v1.42 map. Anyway, figured I probably did something wrong, so just wondering if anyone sees anything obvious or has an answer for what might be going on.
Thanks!