[Gixxersixxerman]

Originally Posted by Kiske

When it is fully done I due a photo op. Assuming I can move the spoiler forward (all the bottom sides of my mounts are solid piece of 3m moulding attachment tape for added support. I can't pull it off, the decklid will bend first. I hope to leave it in the sun all day to make the take let loose a bit easier. Just needs to come forward 1/8: or so so all my posts will be in proper alignment.

Thanks, but, I will pass. I have worked from 4pm to 2am for the past 7 days on mine (not including a 45 hour work week.) I will help you out a bit. The center pillar will also need redone. I cut mind in half and filled it with abs plastic then re-drilled through the center, I ran my wiring through this. It was near impossible to feed the wiring through the side mounts after molding it in. If you don't want to run the 3rd brake light you can get a carbon fiber top half without it. But be warned the existing 3rd brake light will be perfectly blocked when the spoiler is on. I found it a requirement to run the center part. Mine is still removable but, when removed the spoiler wobbles and stresses when driving and extremely when moving the decklid. LMK if you need anymore pictures of the process I used.

I will be sending you a PM and if I run into any issues let you know.. Most likely I'll get a shop to do it. My fiberglass skills are subpar at best