Quote:
Originally Posted by AdrianG
Whoever's paying you $100/hour, I hope it's not for a technical position. It's really not that hard, and all the information you need has been repeated at least once in this thread.
|
It is not that hard, but did you forget about all the early discussion about
:
the conversions in ECU Editor being wrong
the padding or not padding the first X bytes
Checksums being wrong
More than one user "bricking their ECU"
Saving in Bin vs Hex
etc. , etc.
I guess part of my frustration about the tactrix has nothing to do with Flashing and about logging innovate data without an OBD port, so the 50 hours was mostly trying to get the unit to do that.
And I a am C&DH (command & data handling) engineer for NASA spacecraft that cost over $1 billion each. So I have not only "flashed" a LOT of expensive hardware, but I have done it to spacecraft that were a long ways away.
My primary job is writing procedures for loading flight software.
So as I said: maybe due to my job, I am overly anal about getting the instructions right instead of "just do it".