Quote:
Originally Posted by wheelhaus
8- squeeze a small bead (1/8" (3mm) diameter) of silicone sealant onto the taillight side of the foam gasket anywhere it meets the plastic flange and around the hardware (the foam will be squished in these areas)
9- carefully place gasket onto the taillight, and repeat silicone bead on fender side of the gasket
|
Might I suggest using a Removable Caulking as quote
"Use this weather-strip caulk when you need it and then simply peel it away when you don't. Its temporary watertight and weatherproof seal prevents air and moisture penetration"
This should remove any worries about gluing in your tail lights with silicone. It is usual clear and could be used instead of the snot. Just make use it is a thick enough bead that it will hold together when you pull it off.