[ReThink]

I am having some problems with the tablet. Little bit of history: I read my ECU (i also used the options to rotate the display 180 degrees) and when I tried to download the .bin to my computer, the program (version 1.04) crashed stating that the OFT was not initialized. Meanwhile, the OFT went back to trying to calibrate the screen. At this time the screen was black with the serial number, HW rev, and FW rev on the OFT screen. I proceeded to calibrate the screen and started the OFT manager again, the OFT updated, and the software was able to read the "original.bin." I also uploaded the 1.34b to slot 1.

I went back to the car and plugged in the OFT into the ECU and I was greeted with the calibration screen again. I proceeded to calibrate the screen and the OFT interface came up. I tried to click on the tuning icon but the it looks like the information icon was being selected although I was pressing the opposite corner. I was greeted with the serial number of the OFT, HW version, FW version and could not click the back icon.

Several attempts to write to the ECU resulted in the same information screen that I could not back out of.

I disconnected from the OBD and reconnected to the laptop and I was again greeted with the calibration screen and the software crashing because the OFT was not initialized. I finished the calibration and decided to erase everything.

Now when I connect the OFT to the ECU for the initial read, I cannot press the tuning icon as before and only the information icon can be selected albeit from the opposite corner. I tried to click all over the screen and I get a sound that can only be describers as "denied!"

Is there anyway to reset the device back to factory setting because the screen is still 180 degrees rotated so I know that the device was not erased completely. Any help will be greatly appreciated.