Quote:
Originally Posted by Maverick22
Hello, I recently purchased a Rocketbunny Kit, well just the fenders anyways, That's all I really liked about the kit. . I wanted to be able to run a really wde wheel and tire. I had my eyes on a 19x 10.75 with either a 20mm or 35 mm offset, obviously i would have to stack spacers for this setup.
My concern though is that the wheels will be too wide. Would I be safer running a 19x 8.75? +20mm or +35mm
Should I run the 20mm with a 25mm spacer? for a -5mm ofset n the front and a 60mm spacer (which is huge) in the rear fo a -40mm offset??
I am trying to figure this out before I get the kit in the post. Thanks in advance.
I am not very good with offsets especially now that I will have to push the wheel out so far. I don't want much stretch on my tire and do not want to poke much, just o have a clean functional wheel and tire.
|
From my understanding and I've been doing quite a bit of research about this, is in order for it to look proper(not sunk in) you will need to run a wheel w/ in the rear ranging form 10.5-12 wide w/ offsets between -44 - -22. Up front you will need to run a wheel ranging from 9.5-10.5 wide w/ offsets of -25 - -10. Someone correct me if I'm wrong please. This is just what I've been able to come up w/. Now if are going for a more sunk in look than adjust the offset more to zero. Since you are leaning towards the functional aspect, most RB owners run an 18x10.5 +22 w/ spacers. I know one owner that has the Battleship gray RB runs that size w/ a 15mm spacer in the front and 25mm in the rear.