|
So I installed my cooler today. If you want to tee into the hose instead of buying the heater pipe, you need a 3/4"x3/4"x3/8" tee. I actually ended up using 3/4"x3/4"x1/2" tee and was able to slip the 3/8 hose onto the 1/2 line. The 3/8" line runs to the exit of the cooler. I bought the hard line for the exit side that runs next to the injector cover and didn't end up using it because after teeing that line, the bottom of the hard line runs too close to that line and it would make for an awkward fit for hose, so I don't recommend it.
Ps I hate coolant lol.
|