I have Racesengs full pulley kit and this little gem "Reverse Lockout"
repeats their commitment to quality. Of course this is a cosmetic item more then anything and to me, the feel is just great as well being metal versus plastic.
You will need a 3/32 punch to remove the stock roll pin and a small hammer. I did this myself not difficult. However if you had a lending had to hold the wire carrier (below main boot) it would help a ton. Took me over a half hour cause I was fiddling trying to get the carrier up and weird angles to hold it to be able to insert the included threaded bolt for the Raceseng RL to hold & go throuhg the wire carriers top hat. Overall a nice piece, great finish and a just a great touch up piece for the interior to IMO. One last bit of advice is before installed Raceseng lockout, put some grease inside bore to keep friction minimal against the plastic sleeves riding inside the lockout.
