Quote:
Originally Posted by cnk
So you've successfully read your ECU and uploaded the correct map to the OFT? Did you get the checksum pop-up window that says the checksum was corrected?
When you connect the OFT to your car, you have it turned on, but not running correct? When you go to upload and click upload, you select the map and then click next and it fails or it fails before that?
|
Successfully read ecu and uploaded corresponding 1.2 map.
Checksum YES written success YES
When I connect to car, whether key is on or off (not running)
Select tuning, tablet shows: reading tune file, then:
open flash type: professional
Vin number
Ecu file BLANK
hw 100
Fw 116
Also strangely it wants to calibrate its screen every time I connect to anything
@shiv is there a way I can start over?