Yeah, I have got the plate holder completely done. To protect the bumper, I cut two pieces of round foam pads, glued them to the plate holder using 3M trim adhesive and then taped them again with Gorilla tape. This should be fine. The only thing left is to take off the bumper, glue and tape the bigger magnets and I shall be done. Thanks again!
BTW, did you also put a license plate from on the holder? Just curious whether it will fit.
Quote:
Originally Posted by shiumai
i had used a dremel tool to grind them down a bit before flipping the tabs around, but i don't recall whether the protruding holes will fit through the license plate holes or make it sit away from the bracket. either way, it's an easy fix if there's an issue, to make the plate sit flush. you have the bracket right now - reverse the tabs and see. good luck! i'm sure you'll do fine.
|