View Single Post
Old 02-01-2012, 03:31 PM   #987
SUB-FT86
86 Member
 
Join Date: Dec 2010
Drives: 2013 Toyota 86 2.0T (Asphalt)
Location: Atlanta, Ga
Posts: 3,129
Thanks: 126
Thanked 527 Times in 296 Posts
Mentioned: 2 Post(s)
Tagged: 2 Thread(s)
Quote:
Originally Posted by Dimman View Post
Well if the turbo is different, I will assume the compressor may be a bit bigger too. If they are going to a twin scroll for better spool(shocked at how this is considered 'high tech' to tuning communities new to turbos, check out Toyota turbos circa late 1980s...) and bigger IC, I'll make an assumption that the cold side is going to flow a bit more air as well. But probably not significantly more than the outgoing one. And that is the choke point on the engine when it comes to 'easy' mods.

Here is what me and Exage are getting at:

So if the 210 hp/180 whp motor guys were getting 240 whp (+60 whp, nice gain) after mods, I don't think the new ~270 hp (probably ~230 whp) motor guys will see much more than 250 whp after similar mods (~+20 whp). Unless the turbo is significantly upgraded over the outgoing one.
The old turbo was a single scroll that everybody hated on the forum. I actually would never buy a 2.0T GC though. I like N/A so 3.8 was the only option.
SUB-FT86 is offline   Reply With Quote