[JPxM0Dz]

Well my Litespeed intake showed up today and I didn't waste anytime installing it. Installation was pretty straight forward, did a sound tube delete at the same time. Word of warning, this intake is not for the faint of heart. The MAF sensor needs to be slightly modified to fit and sit down properly inside the intake tube. This required digging out my handy dremel and notching out a small piece just under one of the screw locations on the sensor itself and also around the outer perimeter of the sensor so it would fit down into the hole nice and snug. Trying to bore out the actual hole inside the intake tube proved to be impossible with my dremel. Titanium is freaking tuff! Basically all my dremel did was polish the welds lol. This is obviously a design flaw by Litespeed Racing, but then again, there has only a handful of these things made so far and their still in development.

Here's a few pics of the intake in all her glory...