Quote:
Originally Posted by Cross
Are you using the Unichip to control it or an outside source? I would assume outside but thought I would ask as I believe the Q+ does have outputs.
Also with 12.5:1 and 3 PSI I think you would be surprised what a difference the power level is. When done right High Compression and Boost is amazing. If you could I would suggest looking into using E85 if your not already, keep yourself a little safer.
|
The Q has extra outputs too, the Q+ adds additional outputs as well as drivers. We're using an RC Brushless motor/controller that uses simple servo signaling. We'll be using one of the digital outputs set up as a duty cycle signal tied to a boost map. You just have to set the signal to a frequency compatible with the servo, and calculate the duty cycle % to servo % based on frequency.