|
Well follow the DIY for pulling the fuses for fuel pump. Then try and start vehicle to get pressure out. Make sure engine is cold. Or carbecue could happen. Remove the big bulky steel covers the passenger side is the hardest one. I removed the upper brace on the driver side to make room. You should see the fuel rails at this point there are 2 12mm socket head bolts per side.
Also dezoris in his direct injector vid should really be of some help. I would have a magnet on a stick ready. I dropped a few bolts when I did mine. Dont over tight dosent take much torque to strip out the aluminum threads in the head
|