View Single Post
Old 08-01-2013, 01:10 AM   #1
thehapaone
Wasian Ninja
 
thehapaone's Avatar
 
Join Date: Jul 2013
Drives: 2013 Crystal Black Silica BRZ-L
Location: Hillsboro, OR
Posts: 1,919
Thanks: 316
Thanked 624 Times in 432 Posts
Mentioned: 197 Post(s)
Tagged: 0 Thread(s)
Garage
TheHapaOne's CBS BRZ Limited

Current Mod List:
Interior
-JPM Coachworks Dash/Gauge Hood/Knee Pads/Speaker Panels
-JDM Black Interior pieces http://www.ft86club.com/forums/showp...3&postcount=46
-Anarchy Motive California Gold Shift Knob
-Diode Dynamics RGB footwell lighting
-Yospeed Heated Seat Switch Surround
-Perrin Drift Button/Reverse Lockout
-Full interior LED conversion

Exterior/Engine Bay
-Miro 398 18x8.5 +35 Matte Black
-Driveway Labs Version 1 Diffuser Prototype
-Rally Armor Mudflaps
-Perrin Short Antenna
-Perrin Brake Reservoir Coozy
-Tinted Windows
-Yellow Tinted Headlights and Foglights
-Cut and Blacked out Taillights
-Diode Dynamics LED Front/Rear Blinkers and Boomerang Always On Module
-LED Sidemarkers
-Password:JDM Gold Engine Dress-up
-Password:JDM Gold Battery Tie Down
-Debadged Trunk

Performance
-Perrin 2.75" CAI Powder coated Gold
-Perrin Black Inlet Hose
-Perrin 3" Resonated Catback
-Perrin Master Cylinder Brace
-Perrin Oil Cooler
-Nameless Catted FP/OP Prototype
-Tomei UEL Header
-HKS Hipermax SP Coilovers
-Password:JDM Gold Strut Bar/Diagonal Braces
-ATE Type 200 Dot 4 Brake Fluid
-DBA T2t Front/Rear Rotors
-Project Mu HC-800 Front Pads
-Hawk HPS Rear Pads



Dated Change Log:
7/18/2013 - Swapped side markers with smoked ones
7/19/2013 - Windows Tinted 25% all around
7/27/2013 - Perrin Front License Plate Relocation & Shorty Antenna
CF Vinyl covering on drill holes & Subaru letters debadged
8/5/2013 - Perrin Inlet Tube, Master Cylinder Brace, Drop in Filter
8/6/2013 - Apexi RS Extreme Catback Exhaust

That 4.8" really fills out the diffuser
8/12/2013 - Installed Perrin Oil Cap/Filter Cover and Master Cylinder Fluid Coozy
Installed OEM Black Shifter boot Bezel and Sport/TSC Buttons
8/13/2013 - Installed JPM Coachworks dash panels & had Eibach springs installed at Derrin's
9/16/2013 - Password:JDM strut kit and dress up kit installed
9/18/2013 - TOM'S USDM taillights installed - swapped to clear lens with @BRZPDX
11/3/2013 - installed nameless catted front/over pipe
11/23/2013 - tinted Headlights & Foglights Yellow Guys at Tommy's Tint did a good job
12/2/2013 - forgestars came in forgot to get Lug Nuts to fit them though :/ size is 18x9 +36 all around
2/22/2014 - after a while of no real mods decided to finish my interior black out
3/26/2014 - Perrin Cold Air intake and Oil Cooler installed
4/4/2014 - Springtime review http://www.ft86club.com/forums/showp...9&postcount=60
4/5/2014 - Drift Office tune

Some time in April - Installed DBA rotors and Hawk Pads
11/9/2015 - Installed HKS Hipermax SP Coilovers
2/8/2015- Swapped Perrin 2.5" Catback to Perrin 3" Catback

4/17/2015 - Tomei UEL installed and FT86SF Catted Header Removed...Tuned In Eugene by VitTuned



[ame="https://www.youtube.com/watch?v=FSvhSUpCThs"]2013 BRZ Dyno pull/Exhaust Video - YouTube[/ame]
Video Clip for your viewing pleasure

7/21/15 - Forgestars removed Miros installed
7/22/15 - Stickers removed
COMING SOON: Turbo?
__________________
check out my build thread here

Previous Cars: 1970 Chevelle 350 (crashed still have in CA), 2000 Honda Accord Coupe (sold)

Last edited by thehapaone; 07-23-2015 at 08:59 PM. Reason: more stuff done
thehapaone is offline   Reply With Quote
The Following 3 Users Say Thank You to thehapaone For This Useful Post:
Dustin2JZ (08-01-2013), Jason@DSG (05-20-2014), Wolfking (11-03-2013)