Quote:
Originally Posted by MaXimus
Hi Kuya, (Guess)
There is no way you can get a single din in there if you don't cut the metal. Only bit of advice I can give is that you don't cut to much out because when you put everything back together the side should pinch the headunit in place. My dash flexes a little bit so slides out about half an inch.
I'm not sure if my setup is getting engine noise because I'm having a ground issue but I did try to ground the shit out of it. Unfortunately the headunit will be sitting right on top of the airbag module (loads of electronics).
If you need anything let me know I'll help as much as possible.
Regards,
Sam
|
yup, salamat..
there's kinda a way around it. there are a few head units that are about 4" long. from the opening to the metal bracket, its about 4.5".
http://www.sony-asia.com/product/dsx-a30
http://www.crutchfield.com/S-7Dy16b9...C-KD-X200.html
http://www.crutchfield.com/S-eJToKYk...-KMM-100U.html
or for the bluetooth variety, these two:
http://www.sony-asia.com/product/dsx-a50bt
http://www.sonicelectronix.com/item_...ss-625UAB.html
these are head units that about fit in the compartment near the shifter. i went with the boss 625uab, mainly for its bt feature. also got the following aux cable that will hopefully route underneath the hu and into the nexus.
[ame="http://www.amazon.com/Scosche-AUX6FBK-Flat-Aux-Cable/dp/B007LGQ7J4"]Amazon.com: Scosche AUX6FBK Flat Aux Cable: Electronics[/ame]
just need to find a good way to mount the tablet onto the dash panel somehow.