|
Hi Kuya, (Guess)
There is no way you can get a single din in there if you don't cut the metal. Only bit of advice I can give is that you don't cut to much out because when you put everything back together the side should pinch the headunit in place. My dash flexes a little bit so slides out about half an inch.
I'm not sure if my setup is getting engine noise because I'm having a ground issue but I did try to ground the shit out of it. Unfortunately the headunit will be sitting right on top of the airbag module (loads of electronics).
If you need anything let me know I'll help as much as possible.
Regards,
Sam
|