View Single Post
Old 06-19-2013, 01:56 AM   #23
joergasm
Senior Member
 
joergasm's Avatar
 
Join Date: Sep 2012
Drives: Subaru BRZ 2013 - SWP 6MT
Location: Toronto
Posts: 354
Thanks: 97
Thanked 42 Times in 25 Posts
Mentioned: 5 Post(s)
Quote:
Originally Posted by Cameronghanson View Post
I can try!

1. Place lights where they can't be seen (obv) and make sure the wires on the drivers side and the passenger side are facing each other (facing the center) --||-- (sorry I know that's crude but that's basically it, if you need pics I can grab some)
2. Pull off the bezel surrounding the shift knob and unplug the bundle of cables attached to the traction control sport mode module. Strip the black tape off the wires and I believe the small purple wire is the lighting one but you can use a volt meter to test that.
3. There is a screw that holds down the shift unit to the body of the car. This is a good ground. Attach your ground wire to this.
4. Splice in your led lights to the purple wire and wrap it up.
5. Tuck the light wire underneath the side of the main center area with the shifter and all that and the wire should be all hidden.
6. Put the bezel back on and you should be good to go!

Sorry this was all done at work on my phone lol it may be a little simplistic. If you need further details or pics I can probably grab you some. The final product is in that forum above
Quote:
Originally Posted by FRS_Sovereign View Post
So, first off I'm not good with electricity that should be understood. Ok So I bought some LED's from AutoZone ($20) and some electrical tape.

1. The first picture shows the LEDs under the dash with the wire going towards the center.

2. The second, is the side panel removed with the wires showing.

3. The third is the gear shift bezel removed showing the wires.
The wire harness attached to the buttons was removed. I took some insulation of of the purple wire then attached my power wire from the LED's and wrapped each in electric tape. pics 4 and 5 are close ups of the harness.

4. The sixth picture shows how they were grounded to two screws under the bezel.

5. The seventh picture is the side panel in its proper place.

6. Final Result.

Let me know how you like it because I love it. They only turn on if the headlight switch has been engaged. Also sorry about the quality of the photos done with my phone.

Hope this helps.
You both said you tapped into the purple traction control. But one says it turns on with headlights, the other says interior lights. Just want to clarify that.
Also how exactly do you take off the side panels and shifter bezel?

Thanks
__________________
joergasm is offline   Reply With Quote