Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - Chinese Ca-Fi knockoff has been rooted! Torque works!

Pacific · 06-17-2013, 02:21 PM

Trap63 regarding the various connections.
The brake wire, is to be connected to pin 6 on 16pins connector. This will avoid to look DVD and may be change GPS infos during driving this means if brake is not on ie not shielded. Personnaly, although I do not watch video during driving I have connect same directly to shield and is OK.Must point out that on T7019 menu you have the option to use this function or not. Leaving this wire free will certainly have no consequences.
For the rear camera, the vidéo plug to use is noted "CAMERRA" this will be switched on when the wire noted reverse is connected to pin 2 on 28pins connector and rear gear is on.In fact, this pin will give 12v when rear is on.
Regarding root, I have used the last Hal9k firmware for 2.3.7 with new Google Play. Found on 4pda russian forum.
Every things are well functionning, I installed TomTom as GPS and other little things for Android, wifi is also ok. I make various trial on desk as I have not yet the time to put in the car, and this will be the opportunity to have a look on the LEDs.

06-17-2013, 02:21 PM	#767
Pacific Member Join Date: Jun 2012 Drives: 5 Celica since 1978.Now a GT86 Location: France - South Posts: 52 Thanks: 140 Thanked 21 Times in 15 Posts Mentioned: 3 Post(s) Tagged: 0 Thread(s)	Trap63 regarding the various connections. The brake wire, is to be connected to pin 6 on 16pins connector. This will avoid to look DVD and may be change GPS infos during driving this means if brake is not on ie not shielded. Personnaly, although I do not watch video during driving I have connect same directly to shield and is OK.Must point out that on T7019 menu you have the option to use this function or not. Leaving this wire free will certainly have no consequences. For the rear camera, the vidéo plug to use is noted "CAMERRA" this will be switched on when the wire noted reverse is connected to pin 2 on 28pins connector and rear gear is on.In fact, this pin will give 12v when rear is on. Regarding root, I have used the last Hal9k firmware for 2.3.7 with new Google Play. Found on 4pda russian forum. Every things are well functionning, I installed TomTom as GPS and other little things for Android, wifi is also ok. I make various trial on desk as I have not yet the time to put in the car, and this will be the opportunity to have a look on the LEDs.