follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB > Search Forums


Showing results 1 to 30 of 48
Search took 0.01 seconds.
Search: Posts Made By: Compelica
Forum: Electronics | Audio | NAV | Infotainment 07-20-2021, 11:06 PM
Replies: 8
Views: 168
Posted By Compelica
Apparently it's there listed in the manual, where...

Apparently it's there listed in the manual, where for the DDX917WS it is listed as a separate accessory. WS models uses a 3.5mm jack to a proprietary 26 pin Toyota connector, as for the other models...
Forum: Engine, Exhaust, Transmission 07-02-2021, 09:40 AM
Replies: 228
Views: 13,247
Posted By Compelica
My plan to measure the differences is to hook up...

My plan to measure the differences is to hook up an RTA and measure the frequencies at different rev speeds (eg. idle, 2k, 3k, etc) and compare the readings pre-install and post-install. From there...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-24-2021, 03:00 AM
Replies: 59
Views: 2,006
Posted By Compelica
This may or may not be relevant to the discussion...

This may or may not be relevant to the discussion at hand but I do find it interesting.

https://motoiq.com/resurrecting-project-fr-s-greddy-oil-cooler/

In the comments they speculate that the...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-16-2021, 10:14 AM
Replies: 59
Views: 2,006
Posted By Compelica
IIRC the coolant circulation system eventually...

IIRC the coolant circulation system eventually bleeds itself via the reservoir but to quickly relieve air there is a bleed valve close to the center of the engine firewall - however I don't remember...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-16-2021, 01:32 AM
Replies: 59
Views: 2,006
Posted By Compelica
This is anecdotal, but I personally feel that it...

This is anecdotal, but I personally feel that it will be difficult to dictate whether a specific oil would do poor or well without fully understanding the very specific study of tribology (which I...
Forum: Engine, Exhaust, Transmission 06-14-2021, 04:35 AM
Replies: 228
Views: 13,247
Posted By Compelica
Received my hangers a few days back, will report...

Received my hangers a few days back, will report once I get the chance to install them.
Forum: Scion FR-S / Toyota 86 GT86 General Forum 06-13-2021, 10:15 AM
Replies: 23,296
Views: 5,692,057
Posted By Compelica
Some brake pressure testing done today. ...

Some brake pressure testing done today.

Before the brace: 10.37 MPa
After the brace: 11.54 MPa

https://i.imgur.com/7JyA1Qe.jpg
Forum: Issues | Warranty | Recalls / TSB 06-08-2021, 10:33 PM
Replies: 12
Views: 731
Posted By Compelica
Not sure what it could entirely be, but if you...

Not sure what it could entirely be, but if you have access to Techstream you can check two things to help you determine the issue:

1. Check if the ECU is sending the signal to turn on the fan.
2....
Forum: Software Tuning 03-29-2021, 01:52 PM
Replies: 5
Views: 434
Posted By Compelica
Getting the ECU to quickly learn idle stability after a reflash

Figured that it would be applicable to post this here in the Software Tuning section as we deal with these issues more often.

After a reflash the ECU takes some time to relearn fuel trims, and...
Forum: DIY (Do-It-Yourself) Guides 03-20-2021, 11:12 PM
Replies: 130
Views: 18,134
Posted By Compelica
It's in an app called OBD Fusion - however it's a...

It's in an app called OBD Fusion - however it's a paid addon, and the downside is that the PID formula isn't shown (you can only access the values) so along with individual wheel speeds you can...
Forum: DIY (Do-It-Yourself) Guides 03-17-2021, 10:15 PM
Replies: 20
Views: 1,344
Posted By Compelica
Oh no, not about that... :) But Ultramaroon did...

Oh no, not about that... :) But Ultramaroon did mention that our clutch is self adjusting, so technically it would not make a difference on how the rod is positioned against the fork.
Forum: DIY (Do-It-Yourself) Guides 03-17-2021, 09:25 AM
Replies: 20
Views: 1,344
Posted By Compelica
Unfortunately not much of a difference. I had to...

Unfortunately not much of a difference. I had to remove the slave cylinder as I was relubricating the pushrod and clutch fork at that time.
Forum: DIY (Do-It-Yourself) Guides 03-17-2021, 08:54 AM
Replies: 20
Views: 1,344
Posted By Compelica
I explored this the last time as well... but good...

I explored this the last time as well... but good to know there was improvement on your end.

https://www.ft86club.com/forums/showthread.php?t=143028
Forum: Electronics | Audio | NAV | Infotainment 03-08-2021, 04:03 AM
Replies: 42
Views: 2,427
Posted By Compelica
gpvecchi I have made a mistake - the car does go...

gpvecchi I have made a mistake - the car does go on beeping when on reverse. I got confused with another car of mine :/
Forum: Electronics | Audio | NAV | Infotainment 03-07-2021, 09:33 PM
Replies: 42
Views: 2,427
Posted By Compelica
gpvecchi just caught up here... relating to your...

gpvecchi just caught up here... relating to your question mine only has a single long beep when placed into reverse, but will not beep after or like a reverse sensor. Mine has no reverse sensors by...
Forum: Tracking / Autocross / HPDE / Drifting 02-13-2021, 07:55 AM
Replies: 15
Views: 3,316
Posted By Compelica
Just wanted to bring this up - the OBD Fusion app...

Just wanted to bring this up - the OBD Fusion app with the extended parameters has the brake pressure PID, which works well but the app is a little slow in responding. Would have preferred to port...
Forum: Electronics | Audio | NAV | Infotainment 02-02-2021, 08:54 PM
Replies: 42
Views: 2,427
Posted By Compelica
Not an 86, but it sounds exactly the same. ...

Not an 86, but it sounds exactly the same.

https://youtu.be/P_A3jlHUb2s
Forum: Electronics | Audio | NAV | Infotainment 02-02-2021, 02:12 AM
Replies: 42
Views: 2,427
Posted By Compelica
If you mean chirping = beeping, mine is also a...

If you mean chirping = beeping, mine is also a JDM 2015 and it chirps :)
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 01-19-2021, 10:12 AM
Replies: 71
Views: 5,897
Posted By Compelica
Referring to the rear side braces - 80Nm on the...

Referring to the rear side braces - 80Nm on the horizontal lower arm and 110Nm on the diagonal lower arm.
Forum: Issues | Warranty | Recalls / TSB 01-18-2021, 08:09 AM
Replies: 17
Views: 1,139
Posted By Compelica
I had the same problem, though it was on at the...

I had the same problem, though it was on at the passenger's seat - I have a RHD. It's the horizontal bar that adjusts the bottom seat position, try reseating the position and tap on the bar to ensure...
Forum: Engine, Exhaust, Transmission 01-09-2021, 02:34 AM
Replies: 8
Views: 850
Posted By Compelica
Is your ELM327 version a 1.5, or 2.0? 1.5...

Is your ELM327 version a 1.5, or 2.0? 1.5 apparently had better compatibility, you can also use this app to check.

https://play.google.com/store/apps/details?id=com.applagapp.elm327identifier
Forum: Scion FR-S / Toyota 86 GT86 General Forum 01-06-2021, 04:24 AM
Replies: 23,296
Views: 5,692,057
Posted By Compelica
Most of the workshop guys here to do a layer or...

Most of the workshop guys here to do a layer or two of clear urethane to keep it pristine for a few more years.
Forum: Scion FR-S / Toyota 86 GT86 General Forum 12-13-2020, 09:25 PM
Replies: 23,296
Views: 5,692,057
Posted By Compelica
Pulled out the front bumper today to install a...

Pulled out the front bumper today to install a DRL enabler kit (Japanese models do not have DRL as part of regulations, hardware is all there sans wiring). The push pins underneath the bumper were...
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 11-18-2020, 11:07 AM
Replies: 2,589
Views: 273,767
Posted By Compelica
So it looks like the new BRZ maintains its 7400...

So it looks like the new BRZ maintains its 7400 rpm rev limit even with a bigger bore. All things equal, if the bore is increased without changing the stroke, the rev limit rightfully should be lower...
Forum: Engine, Exhaust, Transmission 11-03-2020, 09:02 AM
Replies: 5
Views: 578
Posted By Compelica
Aha, finally got it on how it works, and why it...

Aha, finally got it on how it works, and why it wouldn't work:

https://www.mr2oc.com/threads/extended-clutch-pushrod-from-speedsource.472193/

Carry on, gents.
Forum: Engine, Exhaust, Transmission 11-03-2020, 02:13 AM
Replies: 5
Views: 578
Posted By Compelica
Ah. Is there a mechanism that prevents the...

Ah. Is there a mechanism that prevents the pushrod from extending too far, eg. the clutch fork is already at its maximum travel and to prevent the pushrod from damaging the fork?
Forum: Engine, Exhaust, Transmission 11-03-2020, 12:07 AM
Replies: 5
Views: 578
Posted By Compelica
Adjusting slave cylinder to smoothen 1st-2nd and 3rd-2nd shifts

I came across this post on Minkara (a Japanese automotive blogging platform) and noticed that many 86 owners were advocating this easy tip of reducing difficulty of shifting from 1st to 2nd, and...
Forum: Electronics | Audio | NAV | Infotainment 10-29-2020, 04:04 AM
Replies: 4
Views: 2,734
Posted By Compelica
Bringing this back up from the dead... but if...

Bringing this back up from the dead... but if anyone wants a quicker solution to this, spade connectors will also work nicely. Just slot them in and secure with tape.
...
Forum: Software Tuning 10-13-2020, 05:11 AM
Replies: 5
Views: 552
Posted By Compelica
That makes sense, given the limitations that...

That makes sense, given the limitations that we're bound on stock ECUs. A few posts here also reference the smooth, characteristic curve of the timing map.

Thanks Kodename47 for the tips. Will...
Forum: Software Tuning 09-27-2020, 02:33 PM
Replies: 5
Views: 552
Posted By Compelica
MAF scaling is as good as it gets - LTFT is about...

MAF scaling is as good as it gets - LTFT is about 2-4% which is alright. AFRs go from 11.8 to 11.3 from 5K to redline at WOT... fuelling is tad rich but should be safe for people who are still...
Showing results 1 to 30 of 48

 
Forum Jump

All times are GMT -4. The time now is 04:44 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.