follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 7 1 2345 Last »
Showing results 1 to 30 of 210
Search took 0.08 seconds. Search: Posts Made By: -Phil
Forum: Cars for Sale/Trade 09-18-2018, 05:16 PM
Replies: 9
Views: 3,826
Posted By -Phil
Update: not parting with the swap kit, just going...

Update: not parting with the swap kit, just going to sell the car whole. Getting too much interest in the full car to warrant pulling it apart. Will update thread with Username pic tonight.
Forum: Cars for Sale/Trade 09-15-2018, 08:11 PM
Replies: 9
Views: 3,826
Posted By -Phil
uhhh? the photo's are and have been attached...

uhhh? the photo's are and have been attached sense the thread started....
Forum: Engine Swaps 09-15-2018, 02:35 PM
Replies: 72
Views: 52,029
Posted By -Phil
Parting her out/selling it car is complete,...

Parting her out/selling it car is complete, http://www.ft86club.com/forums/showthread.php?t=130268
Forum: Cars for Sale/Trade 09-14-2018, 11:12 PM
Replies: 9
Views: 3,826
Posted By -Phil
2jz BRZ

Sold
Forum: Engine Swaps 04-07-2018, 03:24 PM
Replies: 181
Views: 53,208
Posted By -Phil
My hero.

My hero.
Forum: Engine Swaps 03-15-2018, 02:01 PM
Replies: 181
Views: 53,208
Posted By -Phil
As Spitfire states here nothing works with this...

As Spitfire states here nothing works with this setup on the AEM, We are using an S2000 Cluster as a display. No a/c, No heat and no ABS/TCS. I would personally not recommend going the route of a can...
Forum: Engine Swaps 03-12-2018, 12:23 PM
Replies: 72
Views: 52,029
Posted By -Phil
Small update from Pure, Motor is in the car....

Small update from Pure, Motor is in the car. Everything is mocked up. Getting all the good stuff. Going with a stock bottom end and a fully built head.

https://i.imgur.com/NG045TS.jpg...
Forum: Engine Swaps 02-21-2018, 05:09 PM
Replies: 72
Views: 52,029
Posted By -Phil
http://tothedeathmedia.com/wp-content/uploads/2016...

http://tothedeathmedia.com/wp-content/uploads/2016/09/White-Flag-1.jpg

Welp Unfortunately I will be giving up on this swap in particular, Spearheading these swaps is always a pain and...
Forum: Engine Swaps 02-09-2018, 03:42 PM
Replies: 1,305
Views: 321,087
Posted By -Phil
Check Out ShmuckBuilt and Sheepybuilt for a...

Check Out ShmuckBuilt and Sheepybuilt for a tucked rad.
Forum: Engine Swaps 02-07-2018, 04:47 PM
Replies: 72
Views: 52,029
Posted By -Phil
If anyone was interested in the MRS Box / Cable...

If anyone was interested in the MRS Box / Cable it is for sale as I have gone in a different direction. Hopefully i will update the thread in a couple of days with new information on the changes I've...
Forum: Engine, Exhaust, Transmission 01-16-2018, 05:52 PM
Replies: 42
Views: 13,882
Posted By -Phil
What are you doing for brake ducting if any? ...

What are you doing for brake ducting if any?

-Phil
Forum: Engine Swaps 12-02-2017, 09:46 AM
Replies: 72
Views: 52,029
Posted By -Phil
Absolutely shoot me a pm!

Absolutely shoot me a pm!
Forum: Engine Swaps 11-30-2017, 12:23 PM
Replies: 72
Views: 52,029
Posted By -Phil
Update, Wiring and can bus has seemingly...

Update,

Wiring and can bus has seemingly been sorted through by Dunnfab in NJ

The car has a bunch of little things that needs to be done which entails the following,

----Alternator wiring -...
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 08-14-2017, 10:08 AM
Replies: 91
Views: 48,672
Posted By -Phil
I would try and find a set of brz/frs STI mounts,...

I would try and find a set of brz/frs STI mounts, i used those for a long time with no issues.
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 08-11-2017, 10:42 AM
Replies: 91
Views: 48,672
Posted By -Phil
It's not messed up. photo bucket requires users...

It's not messed up. photo bucket requires users to pay for hosting as of now.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 08-10-2017, 11:13 AM
Replies: 10
Views: 2,657
Posted By -Phil
I will know.

I will know.
Forum: Engine Swaps 08-08-2017, 03:07 PM
Replies: 72
Views: 52,029
Posted By -Phil
the motor is tilted 13 degrees, that is simply...

the motor is tilted 13 degrees, that is simply the way it was designed to be. if you where to make it upright the shifter would be angled incorrectly.
Forum: Forced Induction 07-30-2017, 10:20 PM
Replies: 27
Views: 16,184
Posted By -Phil
This is on a 9:1 Compression motor, therefore the...

This is on a 9:1 Compression motor, therefore the comparison isn't quite there, on a stock compression motor and e85 it would be around the same.
Forum: Forced Induction 07-14-2017, 02:46 PM
Replies: 2
Views: 1,381
Posted By -Phil
If you don't have ethanol/e85 in your area and...

If you don't have ethanol/e85 in your area and you don't want to pay for race gas, water meth is probably going to be your only/best option for making a good amount of power.
Forum: Forced Induction 07-13-2017, 01:11 PM
Replies: 18
Views: 3,919
Posted By -Phil
Sub 300WHP is always the way to go for longevity.

Sub 300WHP is always the way to go for longevity.
Forum: Engine Swaps 07-07-2017, 08:26 PM
Replies: 72
Views: 52,029
Posted By -Phil
Future manifolds will be divided, this header was...

Future manifolds will be divided, this header was used for the jig, I originally did not plan on doing it hence my collector choice. After talking to Elmer they will make us a divided collector next...
Forum: Engine Swaps 07-07-2017, 07:58 PM
Replies: 72
Views: 52,029
Posted By -Phil
Hey All, the car is pretty much sorted...

Hey All,

the car is pretty much sorted mechanically, all lines are done all that's left mechanically is the throttle and clutch master.

http://i.imgur.com/2uK7ko7.jpg
...
Forum: Forced Induction 07-03-2017, 03:39 PM
Replies: 29
Views: 4,147
Posted By -Phil
That solution really makes no sense, It literally...

That solution really makes no sense, It literally goes against what all of you are saying, My response would stand for the next person who buys it. the fact is a tune paired with data-logging and...
Forum: Forced Induction 07-03-2017, 01:34 PM
Replies: 29
Views: 4,147
Posted By -Phil
Yes really, a turbo that goes fails with...

Yes really, a turbo that goes fails with relatively low miles, a hot-side that fits poorly, a waste gate in position that makes no sense. Tig welds that look like tack welds. that kits on the same...
Forum: Forced Induction 07-03-2017, 12:53 PM
Replies: 29
Views: 4,147
Posted By -Phil
Looks equal quality to the CX racing kits that we...

Looks equal quality to the CX racing kits that we see and tune all the time, People want to spend as little money as possible. At the end of the day the tune and fail-safes is what will keep the car...
Forum: Forced Induction 06-30-2017, 11:52 AM
Replies: 6,004
Views: 2,052,591
Posted By -Phil
An oil cooler kit is almost a must when you do...

An oil cooler kit is almost a must when you do any kind of forced induction on these cars, If you are tracking the car it is required. The Jackson racing oil cooler works great and fits well with the...
Forum: Forced Induction 06-30-2017, 11:36 AM
Replies: 29
Views: 4,147
Posted By -Phil
You would need a proper tuning system such as, ...

You would need a proper tuning system such as,

http://www.moto-east.com/store/subaru/ft86/ft86-tuning.html

Other than that it looks like you'll just need new gaskets then you'll be good to go....
Forum: Forced Induction 06-29-2017, 02:47 PM
Replies: 3
Views: 4,889
Posted By -Phil
Moto-East Forced Induction sale!

http://i.imgur.com/nfsG7BT.jpg

Moto-East will be offering a Half price install rate for the Harrop supercharger kit.

We will also be offering 200-500$ off the install cost of many other...
Forum: Engine Swaps 06-14-2017, 11:59 AM
Replies: 72
Views: 52,029
Posted By -Phil
Hey all, Been a while sense the last update,...

Hey all,

Been a while sense the last update, a Good amount of work got done, The full exhaust is completed and off to ceramic coat. Once thats back all thats left is finishing up the can-bus and...
Forum: Engine Swaps 05-17-2017, 11:29 AM
Replies: 72
Views: 52,029
Posted By -Phil
Hey all, We are indeed planning on making a...

Hey all,

We are indeed planning on making a mount kit and swap kit for this of course.

Here's where we are at

http://i.imgur.com/qByPVDX.jpg
http://i.imgur.com/mTuKUZY.jpg...
Showing results 1 to 30 of 210
Page 1 of 7 1 2345 Last »

 
Forum Jump

All times are GMT -4. The time now is 08:34 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.