follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 2 1 2
Showing results 1 to 30 of 52
Search took 1.82 seconds. Search: Posts Made By: twistednoble
Forum: Engine, Exhaust, Bolt-Ons 12-27-2023, 11:18 PM
Replies: 2
Views: 1,009
Posted By twistednoble
PM'ing for the intake,

PM'ing for the intake,
Forum: Engine, Exhaust, Transmission 12-11-2023, 01:14 AM
Replies: 58
Views: 3,612
Posted By twistednoble
She's all back together and started first crank....

She's all back together and started first crank. Many thanks to those that pitched in and put up with my stubbornness.

The clutch effort is insanely smooth with the new TOB and fresh grease. To...
Forum: Engine, Exhaust, Transmission 12-10-2023, 07:48 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Not a ton. The dowel sticks just far enough out...

Not a ton. The dowel sticks just far enough out of the crank face to kind of locate it and I stuck a punch through one of the bolt holes to keep it located so I know it didn't rotate too far. It's...
Forum: Engine, Exhaust, Transmission 12-10-2023, 04:13 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Thanks for the tip, worked like a charm. I...

Thanks for the tip, worked like a charm.

I see why everyone thinks this is a relatively easy job. Now that I don't have to fight it apart I had the thing split and on the floor from completely...
Forum: Engine, Exhaust, Transmission 12-10-2023, 04:10 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Ring was 45 degrees retarded; I was indeed damn...

Ring was 45 degrees retarded; I was indeed damn close by luck.
Forum: Engine, Exhaust, Transmission 12-10-2023, 03:55 AM
Replies: 58
Views: 3,612
Posted By twistednoble
Ironically I think I'm correct or damn close....

Ironically I think I'm correct or damn close. With the timing at my best guess for TDC on the crank I can see the flat spot on the tone wheel in the inspection window. I wish someone had this...
Forum: Engine, Exhaust, Transmission 12-10-2023, 12:46 AM
Replies: 58
Views: 3,612
Posted By twistednoble
Ok, the reason the ECU isn't throwing...

Ok, the reason the ECU isn't throwing misalignment codes is that the set conditions require:
Battery Voltage 11V or more
60 seconds of engine running
122F coolant temp or higher

And a couple...
Forum: Engine, Exhaust, Transmission 12-10-2023, 12:08 AM
Replies: 58
Views: 3,612
Posted By twistednoble
Alright, now before I get too deep; is there a...

Alright, now before I get too deep; is there a way to check if it is properly clocked without tearing the whole thing apart?

Somewhere in the last three moves in the past two years I lost my...
Forum: Engine, Exhaust, Transmission 12-09-2023, 11:50 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Thanks, now I just need a way to keep the timing...

Thanks, now I just need a way to keep the timing wheel anchored since I almost definitely pressed the dowel flat into the crank.
Forum: Engine, Exhaust, Transmission 12-09-2023, 11:48 PM
Replies: 58
Views: 3,612
Posted By twistednoble
I have many many cuss words to say. I guess I'll...

I have many many cuss words to say. I guess I'll be speed running a transmission drop again tomorrow. I really need this damn car to be back on the road on Monday.
Forum: Engine, Exhaust, Transmission 12-09-2023, 11:35 PM
Replies: 58
Views: 3,612
Posted By twistednoble
I would have noticed it since I was trying to...

I would have noticed it since I was trying to figure out how to hold the timing plate since there was no way to keep it against the crank while lined the flywheel up.

I have the whole thing back...
Forum: Engine, Exhaust, Transmission 12-09-2023, 11:26 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Yea I really feel like I'm insane. I was spinning...

Yea I really feel like I'm insane. I was spinning that tone wheel on the back of the crank smoothly, trying to get it to line up with the bolt holes. There wasn't a key present for me to catch on or...
Forum: Engine, Exhaust, Transmission 12-09-2023, 11:06 PM
Replies: 58
Views: 3,612
Posted By twistednoble
How is that key anchored in the crank? Is it...

How is that key anchored in the crank? Is it fixed in one spot and the hole is blind or can it be shoved through the crank to make the trigger wheel flush? I'm looking through iRacer's build thread...
Forum: Engine, Exhaust, Transmission 12-08-2023, 01:55 PM
Replies: 58
Views: 3,612
Posted By twistednoble
I need crank, no start, no code ideas now. I...

I need crank, no start, no code ideas now. I reflashed but I'm still not having the engine catch and run. It will sometimes run just a little bit but it won't rev up to a cold idle and the starter...
Forum: Engine, Exhaust, Transmission 12-08-2023, 01:48 PM
Replies: 58
Views: 3,612
Posted By twistednoble
I did, there was a little bit of engine oil on...

I did, there was a little bit of engine oil on the back of the plate. That helped me identify which direction it was supposed to go; teeth toward engine.
Forum: Engine, Exhaust, Transmission 12-07-2023, 11:12 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Truly, an ongoing debacle. It's all back...

Truly, an ongoing debacle.

It's all back together, plugged in, and full of oil, but now she doesn't want to start. It was full dead for a bit but then I had it catch and almost take off. I...
Forum: Engine, Exhaust, Transmission 12-06-2023, 08:11 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Going to doublecheck alignment and then put it...

Going to doublecheck alignment and then put it back on. Hopefully with the hole cleaned out it will shoot down the dowels this time.
Forum: Engine, Exhaust, Transmission 12-06-2023, 08:10 PM
Replies: 58
Views: 3,612
Posted By twistednoble
I don't mean to be high and mighty but... ...

I don't mean to be high and mighty but...

HAHA! I WAS RIGHT!

Big breath of relief all around.

Pulled the bolts, backed it out once again the right side being the sticking point. Shined a...
Forum: Engine, Exhaust, Transmission 12-06-2023, 06:39 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Is that a yes on it should shoot down the dowels...

Is that a yes on it should shoot down the dowels with little resistance?
Forum: Engine, Exhaust, Transmission 12-06-2023, 06:17 PM
Replies: 58
Views: 3,612
Posted By twistednoble
That's what I was afraid of hearing. Going to the...

That's what I was afraid of hearing. Going to the bolts was my last resort after about of an hour and a half of screwing with the jacks and eventually just man handling the trans to try and get it to...
Forum: Engine, Exhaust, Transmission 12-06-2023, 12:38 AM
Replies: 58
Views: 3,612
Posted By twistednoble
Same struggle putting it back together

Going back together. I rode up to the dealer and picked up a spring clip and a new MLS gasket for the front pipe yesterday then spent the rest of the day thawing out. I did go out and get the new...
Forum: Engine, Exhaust, Transmission 12-04-2023, 03:27 AM
Replies: 58
Views: 3,612
Posted By twistednoble
Looking pretty good for a 90k mile clutch and...

Looking pretty good for a 90k mile clutch and flywheel.

https://media.discordapp.net/attachments/1043698433913008131/1181140276710998096/20231203_182747.jpg
...
Forum: Engine, Exhaust, Transmission 12-04-2023, 03:22 AM
Replies: 58
Views: 3,612
Posted By twistednoble
I'll look at it harder tomorrow afternoon. The...

I'll look at it harder tomorrow afternoon. The whole thing's been brought to a screeching halt again because 86speed doesnt incude that wire retainer spring for the pivot ball in their kit even...
Forum: Engine, Exhaust, Transmission 12-03-2023, 05:28 PM
Replies: 58
Views: 3,612
Posted By twistednoble
How does this look as far as bearing surface...

How does this look as far as bearing surface damage? Surface is a bit rough but no harsh ridges present so I think I can call it aftermarket grease retention features ��....
Forum: Engine, Exhaust, Transmission 12-03-2023, 04:14 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Dead on the money my friend. I got to keep both...

Dead on the money my friend. I got to keep both of them.

https://media.discordapp.net/attachments/508461225336766485/1180980191959449721/20231203_151321.jpg
Forum: Engine, Exhaust, Transmission 12-02-2023, 07:41 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Oh yea, this was a job I was expecting to be...

Oh yea, this was a job I was expecting to be moderately difficult so I slated two days on it, and in typical fashion of car maintenance jobs I havent done before it's become a four day ordeal and its...
Forum: Engine, Exhaust, Transmission 12-02-2023, 05:58 PM
Replies: 58
Views: 3,612
Posted By twistednoble
I've been screwing around with it for a while now...

I've been screwing around with it for a while now and I' probably gonna call it a day. I've got about a 1/4-1/8" gap around the whole thing but the right side is refusing to come as easily as the...
Forum: Engine, Exhaust, Transmission 12-02-2023, 04:32 PM
Replies: 58
Views: 3,612
Posted By twistednoble
Hallelujah boys, we got a damn crack finally....

Hallelujah boys, we got a damn crack finally. More prying and wiggling is needed but there is some progress.
...
Forum: Engine, Exhaust, Transmission 12-02-2023, 04:16 PM
Replies: 58
Views: 3,612
Posted By twistednoble
You must have some fancy prybars, I'm struggling...

You must have some fancy prybars, I'm struggling to snake a bar between the rack and the front subframe to get to the spot you highlighted.

Better a flood of information than leaving out some...
Forum: Engine, Exhaust, Transmission 12-02-2023, 04:13 PM
Replies: 58
Views: 3,612
Posted By twistednoble
I reviewed the thread, how much issue did you...

I reviewed the thread, how much issue did you have getting it moving initially? My current clusterfuck is that the transmission is firmly mated to the back of the engine still.
Showing results 1 to 30 of 52
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 08:08 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.