follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results

Register and become an FT86Club.com member. You will see fewer ads

Page 1 of 5 1 2345
Showing results 1 to 30 of 137
Search took 0.01 seconds. Search: Posts Made By: Muskoka800
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-22-2025, 12:48 PM
Replies: 7
Views: 298
Posted By Muskoka800
It’s been some time since I worked down there but...

It’s been some time since I worked down there but could you not drill and tap the stripped hole for a 9 or 10mm bolt?
Forum: Engine, Exhaust, Transmission 09-25-2025, 11:12 AM
Replies: 11
Views: 6,475
Posted By Muskoka800
I used Permatex Ultra Grey and blue Loctite for...

I used Permatex Ultra Grey and blue Loctite for this same operation 5 years ago and have had zero issues to date.
My Ontario dealer also recommended Ultra when I called for Three Bond which I later...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 09-24-2025, 12:03 PM
Replies: 3
Views: 531
Posted By Muskoka800
Or remove the lamps and install a brake cooling...

Or remove the lamps and install a brake cooling set-up.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-08-2025, 11:45 AM
Replies: 8
Views: 1,555
Posted By Muskoka800
Don’t be afraid to try the Stoptech ‘Sport’ pads....

Don’t be afraid to try the Stoptech ‘Sport’ pads.
I’ve run them for a few years for both lapping days and general driving.
They hold up well and are less expensive than most however the first...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-23-2025, 11:34 AM
Replies: 14
Views: 2,655
Posted By Muskoka800
If nothing else, the swaybar bushings pictured...

If nothing else, the swaybar bushings pictured are beyond finished. They should fit tight to the bar. No gaps.
Forum: Tracking / Autocross / HPDE / Drifting 05-02-2025, 11:51 AM
Replies: 7
Views: 1,583
Posted By Muskoka800
I’ve seen 1/2” birch veneered plywood used for...

I’ve seen 1/2” birch veneered plywood used for DYI splitter projects (see YouTube).
Forum: Engine, Exhaust, Transmission 03-11-2025, 12:28 PM
Replies: 13
Views: 5,642
Posted By Muskoka800
Protect that CV from heat. I put header wrap on...

Protect that CV from heat.
I put header wrap on ~18” of the exhaust where it runs under the drivers side axle. No CV issues after many summer track days.
Forum: Want-To-Buy Requests 02-05-2025, 03:38 PM
Replies: 8
Views: 3,754
Posted By Muskoka800
My point is that a car which changes hands every...

My point is that a car which changes hands every year could be a problem child. Why would multiple owners dispose of this car so quickly? Being a special edition should give it a collectibility...
Forum: Canada Classifieds 11-15-2024, 12:47 PM
Replies: 17
Views: 3,801
Posted By Muskoka800
It appears that the slutty ads have driven the...

It appears that the slutty ads have driven the enthusiasts away.
Forum: Engine, Exhaust, Bolt-Ons 10-09-2024, 10:45 AM
Replies: 2
Views: 995
Posted By Muskoka800
You may be interested in checking the Canadian...

You may be interested in checking the Canadian Classifieds” sub-forum for a post by Ashy23, a Toronto area re-cycler who may be interested and pays well.
Good Luck!
Forum: CANADA 09-20-2024, 12:17 PM
Replies: 5
Views: 1,947
Posted By Muskoka800
Good to hear the Ohlins have great stamina. Mine...

Good to hear the Ohlins have great stamina. Mine have nowhere near that mileage.
Regarding your clunky rear. You may benefit from the Energy Suspension parts I have posted for sale in the Canadian...
Forum: Tracking / Autocross / HPDE / Drifting 09-19-2024, 10:46 AM
Replies: 27
Views: 6,541
Posted By Muskoka800
May simply be an Extreme Contact Force with...

May simply be an Extreme Contact Force with A052ish tread. Perhaps a stickier compound. It even has the Forces checkered flag pattern on the sidewall. I believe Continental owns Hoosier.
Forum: Engine, Exhaust, Bolt-Ons 07-28-2024, 11:14 AM
Replies: 37
Views: 7,210
Posted By Muskoka800
Or the seller just chooses not to respond to...

Or the seller just chooses not to respond to low-ballers???
Forum: Brakes, Suspension, Chassis 06-30-2024, 06:15 PM
Replies: 7
Views: 1,304
Posted By Muskoka800
Two thumbs up for Koni Yelows! I ran a set with...

Two thumbs up for Koni Yelows!
I ran a set with TRD springs for a couple years of DD and HPDE days with the adjustability bringing many smiles.
Since retiring my FRS is more HPDE and less DD,...
Forum: Forced Induction 06-16-2024, 12:38 PM
Replies: 5,014
Views: 1,751,869
Posted By Muskoka800
I didn’t examine it for branding but do assume it...

I didn’t examine it for branding but do assume it is a K&N filter un-oiled.
Forum: Forced Induction 06-14-2024, 12:10 PM
Replies: 5,014
Views: 1,751,869
Posted By Muskoka800
I purchased the “dry” filter from Summit Racing...

I purchased the “dry” filter from Summit Racing after receiving and using the oiled filter included with the used Edelbrock kit I purchased.
I was disappointed upon opening the package to find the...
Forum: Forced Induction 04-12-2024, 01:09 PM
Replies: 5,014
Views: 1,751,869
Posted By Muskoka800
The intake manifold gaskets are OEM parts. I...

The intake manifold gaskets are OEM parts. I installed new ones with the S/C however the original ones removed were perfectly identical to the new. They are a silicone o-ring type. Not expensive...
Forum: Issues | Warranty | Recalls / TSB 02-20-2024, 12:35 PM
Replies: 18
Views: 3,366
Posted By Muskoka800
I re-used all the full rails when installing my...

I re-used all the full rails when installing my SC. Did use new seals of course. Edelbrock’s instructions were to re-install the rails.
Thousands of kilometres of happy motoring since.
Note: the...
Forum: Forced Induction 11-14-2023, 10:40 AM
Replies: 5,014
Views: 1,751,869
Posted By Muskoka800
It’s not a bad job with the help of a buddy to...

It’s not a bad job with the help of a buddy to lower and raise the gearbox. Mind-you it mAy be awkward to access the upper bell housing bolts and slave cylinder bolts with the S/C in place. Mine...
Forum: Forced Induction 11-13-2023, 12:20 PM
Replies: 5,014
Views: 1,751,869
Posted By Muskoka800
Sounds like your clutch is slipping. Either...

Sounds like your clutch is slipping.
Either it’s worn out or possibly fluid contaminated. Any dripping below?
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-17-2023, 12:53 PM
Replies: 12
Views: 3,247
Posted By Muskoka800
Food for thought. You might consider Stoptech...

Food for thought.
You might consider Stoptech Sport pads. I enjoy them.
They never squeal, don’t dust too badly and last. Don’t tailgate as the first cold stop will be delayed a second like any...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-20-2023, 06:49 PM
Replies: 61
Views: 7,923
Posted By Muskoka800
:lol: Either your sense of humour is just plain...

:lol:
Either your sense of humour is just plain nasty or you’re not old enough to remember rotor turning.
Whichever, I like it!
:clap:
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-19-2023, 10:47 AM
Replies: 61
Views: 7,923
Posted By Muskoka800
Getting close. We’re planning a TMP day for...

Getting close. We’re planning a TMP day for October. If you wish, shoot me a PM with your cell number and I’ll advise our date. I’m looking forward to bolting up the Yok’s and turning some laps....
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-12-2023, 06:40 PM
Replies: 61
Views: 7,923
Posted By Muskoka800
Take Toyota’s service manual requirements with a...

Take Toyota’s service manual requirements with a ‘grain of salt’. They play it safe and replace many items which may not be at end of life. That’s why dealer serviced Toyotas last forever....
Forum: Tracking / Autocross / HPDE / Drifting 09-03-2023, 01:19 PM
Replies: 14
Views: 9,651
Posted By Muskoka800
I am in the process of adding an oil...

I am in the process of adding an oil pressure/temp gauge.
I must soon remove the oil pan to resolve its RTV leak and thought this a good time to slip in a baffle plate. Perhaps, by the sounds of it...
Forum: Engine, Exhaust, Transmission 08-19-2023, 02:58 PM
Replies: 18
Views: 3,877
Posted By Muskoka800
2. I solved V-Clamp joint leakage with red...

2. I solved V-Clamp joint leakage with red high-temp silicone on the sealing surfaces prior to clamping.
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 07-13-2023, 06:25 PM
Replies: 15
Views: 11,122
Posted By Muskoka800
Amazon

Amazon
Forum: Engine, Exhaust, Transmission 07-04-2023, 12:06 PM
Replies: 4
Views: 1,569
Posted By Muskoka800
Hmmmm. The TRD kit looks identical (re-labelled)...

Hmmmm. The TRD kit looks identical (re-labelled) to the K&N kit I have in stock.
If I recall, back in the day the kit did come with aerosol oil but has changed over the years.
Now that you have...
Forum: Engine, Exhaust, Transmission 07-03-2023, 12:17 PM
Replies: 4
Views: 1,569
Posted By Muskoka800
I cannot comment on AFE products. Have not used...

I cannot comment on AFE products. Have not used them.
I would suspect that the TRD filter is a K&N product.
Perhaps try K&N filter cleaning and oiling products.
Regarding over-oiling. This can...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-02-2023, 07:13 PM
Replies: 8
Views: 1,760
Posted By Muskoka800
I was concerned going from Pedders & Koni’s to...

I was concerned going from Pedders & Koni’s to Ohlins but was pleasantly surprised that any noise wasn’t noticeable over tire noise and exhaust.
I’m running double camber bolts with the Ohlin top...
Showing results 1 to 30 of 137
Page 1 of 5 1 2345

 
Forum Jump

All times are GMT -4. The time now is 03:00 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.