follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 500
Search took 0.03 seconds.
Search: Posts Made By: B T
Forum: Forced Induction 03-26-2024, 11:57 AM
Replies: 275
Sticky: FI Dyno thread
Views: 241,108
Posted By B T
https://www.ft86club.com/forums/picture.php?albumi...

https://www.ft86club.com/forums/picture.php?albumid=2897&pictureid=13207
IAG Closed Deck Block
Cometic Head Gasket (lowering compression to 12.2:1)
Edelbrock Supercharger with 2.70" pulley
E80...
Forum: Forced Induction 03-14-2024, 02:18 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
It was just a future proof investment made when...

It was just a future proof investment made when purchasing the block. Less cylinder wobble is always a good thing. It hasn't had any significant effect on coolant temperatures.
Forum: Forced Induction 03-13-2024, 08:07 AM
Replies: 4,944
Views: 1,458,503
Posted By B T
nah, it's E85. Both Zach and I were surprised it...

nah, it's E85. Both Zach and I were surprised it wasn't more power. IAG closed deck block, 12.2:1 static compression, 2.70 pulley.
Forum: Forced Induction 03-11-2024, 05:58 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
Finally did a Dyno check since I wasn't...

Finally did a Dyno check since I wasn't comfortable doing a 140mph run on the street for tuning purposes. Here's what we have for now....
Forum: Issues | Warranty | Recalls / TSB 01-27-2024, 06:38 PM
Replies: 16
Views: 1,241
Posted By B T
As they suggested above, check your coolant...

As they suggested above, check your coolant levels. If you're low enough it wont make it to the heater core and will cause additional issues such as overheating. Hopefully its just a little low and...
Forum: Forced Induction 01-24-2024, 11:07 AM
Replies: 4,944
Views: 1,458,503
Posted By B T
I switched from the original tank to the upgraded...

I switched from the original tank to the upgraded V2 tank a couple years ago, it has a little more volume and the part number is available online.
Forum: Forced Induction 01-12-2024, 10:53 AM
Replies: 13
Views: 839
Posted By B T
The original tune should exist in the ecutek...

The original tune should exist in the ecutek library
Forum: Forced Induction 11-13-2023, 02:35 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
dpfarr yeah, sounds like clutch slippage. stock...

dpfarr yeah, sounds like clutch slippage. stock clutch? changed clutch fluid in the last couple years?
Forum: Forced Induction 10-19-2023, 05:09 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
If anyone wants to separate their temp from the...

If anyone wants to separate their temp from the pressure and use two different MAP sensors, Ballenger has a good deal on a pre-wired pigtail.
...
Forum: Forced Induction 10-19-2023, 02:17 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
That is indeed suspiciously cheap but they go on...

That is indeed suspiciously cheap but they go on sale here and there. I would ensure its a Bosch part and not some knockoff. AutoHausAZ currently has one on sale for $27.99 plus shipping. That's in...
Forum: Engine Swaps 09-06-2023, 11:00 AM
Replies: 472
Views: 87,177
Posted By B T
Sorry to see it didn't turn out quite like you...

Sorry to see it didn't turn out quite like you wanted. It was an interesting build to say the least. Good luck!
Forum: Forced Induction 08-15-2023, 09:46 AM
Replies: 4,944
Views: 1,458,503
Posted By B T
The ABS and and ECM modules are separate so I...

The ABS and and ECM modules are separate so I wouldn't expect them to be related unless you have a a tear in the harness somewhere and it's grounding out. Have you ever replaced your direct injectors...
Forum: Transmission and Driveline 08-14-2023, 11:11 AM
Replies: 13
Views: 1,728
Posted By B T
I had it sitting up for a while came back and...

I had it sitting up for a while came back and forgot to check the heading, oops.
Forum: Transmission and Driveline 08-12-2023, 09:59 AM
Replies: 13
Views: 1,728
Posted By B T
Who's the manufacturer on that driveshaft?

Who's the manufacturer on that driveshaft?
Forum: Forced Induction 08-01-2023, 01:21 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
Sounds like you may need a new tensioner. I'm...

Sounds like you may need a new tensioner. I'm still using the 995 with my 2.70 pulley and never sheared off any ribs. I replaced the tensioner at 60k miles when the original engine blew. Tons of...
Forum: Forced Induction 07-28-2023, 10:20 AM
Replies: 4,944
Views: 1,458,503
Posted By B T
For those of you running the remote MAP sensor...

For those of you running the remote MAP sensor located on the edelbrock supercharger, i did a mod to bring down the reported IATs closer to where they should be and it seems to have worked. I was...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 07-26-2023, 01:37 PM
Replies: 8
Views: 1,865
Posted By B T
I thought it was lifetime oil?! Seriously though,...

I thought it was lifetime oil?! Seriously though, all just depends on your driving type and quality of oil. if you do a lot of short trips without fully warming the oil to burn off condensation in...
Forum: Forced Induction 07-05-2023, 09:00 AM
Replies: 4,944
Views: 1,458,503
Posted By B T
It was the shaft of the butterfly valve itself....

It was the shaft of the butterfly valve itself. I'm only on my 2nd vacuum actuator, been lucky to not have as many problems as others. Sorry, not pics but it was about 1/4 inch total movement.
Forum: Forced Induction 07-04-2023, 05:38 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
So, I ran into an issue where my car wasn't...

So, I ran into an issue where my car wasn't experiencing full acceleration on a regular basis. At first I thought it was throttle body not opening all the way as throttle body failures have been...
Forum: Forced Induction 06-29-2023, 08:01 AM
Replies: 14
Views: 1,563
Posted By B T
You mean blow the engine? The only thing you...

You mean blow the engine? The only thing you would be doing is lowering your IATs, never heard of someone blowing an engine by spraying nitrous on an air to water intercooler. Even if somehow you...
Forum: Forced Induction 06-26-2023, 03:16 PM
Replies: 14
Views: 1,563
Posted By B T
That's a great way to do it, unfortunately not...

That's a great way to do it, unfortunately not legal to run on a track day. Would be my go to for 1/4 mile though.
Forum: Software Tuning 06-25-2023, 02:08 PM
Replies: 329
Views: 118,702
Posted By B T
Tried cleaning the connection, reconnecting all...

Tried cleaning the connection, reconnecting all connectors. Ended up ordering a 2nd one just to rule everything out. It went out mid drive.
Forum: Software Tuning 06-23-2023, 10:14 AM
Replies: 329
Views: 118,702
Posted By B T
If my bluetooth reads the correct ethanol...

If my bluetooth reads the correct ethanol percentage but the ecu no longer sees a change at the O2 sensor plug, what might be the issues? No tuning changes have happened, the signal just dropped out...
Forum: Forced Induction 06-20-2023, 08:40 AM
Replies: 14
Views: 1,563
Posted By B T
I've been thinking about it for a minute but...

I've been thinking about it for a minute but haven't tested anything yet. Here's what I've got.

Chiller Box
Room is at premium in the engine bay, if you just replaced the stock tank with a...
Forum: Forced Induction 06-13-2023, 01:55 PM
Replies: 2
Views: 631
Posted By B T
post it over in the edelbrock discussion

post it over in the edelbrock discussion
Forum: Forced Induction 05-23-2023, 05:11 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
Mine pulls from the brake booster line.

Mine pulls from the brake booster line.
Forum: Forced Induction 05-23-2023, 02:53 PM
Replies: 4,944
Views: 1,458,503
Posted By B T
How many mounting bolts does it have? I seem to...

How many mounting bolts does it have? I seem to remember the original had 3 and the new has 2. I replaced mine with the newer version about 3/4 years ago and haven't change it since. 20k driven since...
Forum: Forced Induction 05-22-2023, 10:27 AM
Replies: 4,944
Views: 1,458,503
Posted By B T
My car threw a P0171 code the other day, checked...

My car threw a P0171 code the other day, checked my OBD2 and found a 24% LTFT. Turns out the Delicious D-Box DESS module quit sending its signal to the ECU but was still reading the percentage over...
Forum: Forced Induction 05-17-2023, 09:03 AM
Replies: 14
Views: 1,917
Posted By B T
Smaay Slap the original stock tune on it and limp...

Smaay Slap the original stock tune on it and limp it down the road with the original accessory belt. So, just don't hook up the supercharger belt and go easy on it.
Forum: Forced Induction 04-26-2023, 08:38 AM
Replies: 4,944
Views: 1,458,503
Posted By B T
I actually bypassed mine but that may not be a...

I actually bypassed mine but that may not be a great idea for you in NY. Can you find a hose with a built in elbow to replace it with?
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -4. The time now is 05:01 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.