follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 4 1 234
Showing results 1 to 30 of 100
Search took 0.71 seconds. Search: Posts Made By: snowtaipan
Forum: Forced Induction 01-23-2024, 06:39 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
Isn't that the same one?

Isn't that the same one?
Forum: Forced Induction 01-22-2024, 12:37 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
Coolant tank swap?

Hey all, I've got the old white coolant tank and it's leaking. I think the cap isn't sealing properly, and when I tighten it down fully it pops off. Anyone run into this, or swapped it?

I was...
Forum: Forced Induction 03-20-2023, 06:22 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
That's disappointing that denso could have a QAQC...

That's disappointing that denso could have a QAQC issue like that, but it is what it is.

I'm running a stock pulley and 93. And my tune is from Delicious with ECUTEK.

I think I'm gonna go to...
Forum: Issues | Warranty | Recalls / TSB 03-20-2023, 06:17 PM
Replies: 14
Views: 1,732
Posted By snowtaipan
Chicken or the egg indeed. So possible theory ...

Chicken or the egg indeed. So possible theory
Ceramic was damaged prior to install
That causes the metal core to pop or break, along with the rear portion of the ceramic
The compression then...
Forum: Forced Induction 03-19-2023, 11:16 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
Cyl 2 denso plug fail

Check it out y'all! Anyone got any idea of the cause? The core is pushed in 3/8" but the tips aren't bent.
Forum: Issues | Warranty | Recalls / TSB 03-19-2023, 11:09 PM
Replies: 14
Views: 1,732
Posted By snowtaipan
I was thinking about running my bore scope in...

I was thinking about running my bore scope in there, but I have all the parts and the threads are fine.

I'm still confused about what damage could shove the plug core back 3/8".
Forum: Issues | Warranty | Recalls / TSB 03-19-2023, 01:52 PM
Replies: 14
Views: 1,732
Posted By snowtaipan
Definitely more than a hairline on the ceramic I...

Definitely more than a hairline on the ceramic I think.

Anyone seen this before? The core is blown back into the body, no damage to the arms. I'm guessing too much fuel or boost?
Forum: Issues | Warranty | Recalls / TSB 03-19-2023, 01:50 PM
Replies: 14
Views: 1,732
Posted By snowtaipan
Not so much bud, I've got 12 years of...

Not so much bud, I've got 12 years of professional experience and did the install myself.

I'm about to add new pics, but it looks like to plug core was blown out, I'm guessing too much fuel or...
Forum: Issues | Warranty | Recalls / TSB 03-12-2023, 12:38 PM
Replies: 14
Views: 1,732
Posted By snowtaipan
Angry P0302 solved I guess. FML

Well, went to swap the coil from 2 to 4 and found half the spark plug in the coil from 2. Guess I don't need to do that test.

Anyone got a good engine shop around Clarksville TN?
Forum: Issues | Warranty | Recalls / TSB 03-10-2023, 03:12 PM
Replies: 14
Views: 1,732
Posted By snowtaipan
I had the same thought, I'll probably run from 2...

I had the same thought, I'll probably run from 2 to 4 and see what happens. Is there an ohms check for the coil pack?
Forum: Issues | Warranty | Recalls / TSB 03-08-2023, 07:33 PM
Replies: 14
Views: 1,732
Posted By snowtaipan
P0302 17 BRZ EDELBROCK SC/W DELICIOUS

Hey y'all, my DD decided after a few months to throw a cyl 2 misfire.

Background, swapped to a stage 2 daily by Southbend about 3 months ago. No issues until today. Fuel consumption has been...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 03-08-2023, 07:13 PM
Replies: 44
Views: 50,310
Posted By snowtaipan
Same, still broken

Same, still broken
Forum: Forced Induction 11-09-2022, 07:01 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
Oil leak on rear SC

Hey everyone! I'm hoping the image is clear, cell phone ain't the best for this lol. Anyhow, I've got a class 1 leak on the rear of my Edelbrock. I want to get it resealed but Edelbrock says they...
Forum: Forced Induction 09-01-2022, 11:17 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
Log from a drive tonight. If anyone has any ideas...

Log from a drive tonight. If anyone has any ideas on more specific parameters that might provide more insight, please let me know.
https://datazap.me/u/snowtaipan/p015a-p015b?log=0&data=28
Forum: Forced Induction 09-01-2022, 06:41 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
Fair question, but no the O2 is fine and works...

Fair question, but no the O2 is fine and works with no issue on the tune from Edelbrock. Haven't actually needed with the sensor, stock exhaust.
Forum: Forced Induction 09-01-2022, 06:29 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
CEL P015B P015A

Hey all, anyone else seen these codes? I recently shifted to Delicious and it's been nothing but trouble. Got an updated tune and did an idle realest, 12 days later the fault came back Called...
Forum: Forced Induction 08-21-2022, 12:57 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
So I'm just spitballing, but you might want to do...

So I'm just spitballing, but you might want to do the VVT and idle relearn steps, and reinforce the grounds for the alternator, engine to frame, and radiator. All should be cheap fixes and have no...
Forum: Forced Induction 07-19-2022, 11:29 AM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
Do you have the idle relearn procedures handy?

Do you have the idle relearn procedures handy?
Forum: Forced Induction 07-18-2022, 06:54 PM
Replies: 4,964
Views: 1,478,313
Posted By snowtaipan
Idle issues with delicious tune

Idle will jump to 1.5k for about 3 second when stopping, drops to 600 for 3 second then evens out. The delicious tune had thrown CELs before. They fixed it but I'm again getting issues and had two...
Forum: Forced Induction 06-17-2022, 08:55 AM
Replies: 0
Views: 587
Posted By snowtaipan
Unhappy p1170/0172 and c1201

Hey y'all, I've been problem free for quite some time and loving my SC. Yesterday morning it threw ALL the CELs at me.

Backstory; Edelbrocks initial CARB tune caused my LTFT to max out. After a...
Forum: Software Tuning 06-22-2021, 06:26 PM
Replies: 9
Views: 2,425
Posted By snowtaipan
17 BRZ with Edelbrock SC tune options

Hey all, I'm living near Clarksville TN and I'm trying to find a tuner who can drop an ECUTek tune in me that can support 91-93 octane. My inquiries have gotten... Mixed results.

The goal is to...
Forum: Engine, Exhaust, Bolt-Ons 08-05-2020, 07:57 PM
Replies: 13
Views: 2,355
Posted By snowtaipan
Sale pending

Sale pending
Forum: Exterior Parts (Aero, Lighting, Etc.) 08-05-2020, 07:55 PM
Replies: 3
Views: 971
Posted By snowtaipan
Sale closed.

Sale closed.
Forum: Exterior Parts (Aero, Lighting, Etc.) 08-04-2020, 08:05 AM
Replies: 3
Views: 971
Posted By snowtaipan
Sale pending

Sale pending
Forum: Engine, Exhaust, Bolt-Ons 08-03-2020, 08:51 PM
Replies: 13
Views: 2,355
Posted By snowtaipan
I'm selling everything in the box, not interested...

I'm selling everything in the box, not interested in a partout deal.

I'll make a final call on Wednesday in case a local wants to grab it, current best was outside the forum for $250 in NC.
Forum: Engine, Exhaust, Bolt-Ons 08-03-2020, 08:28 PM
Replies: 13
Views: 2,355
Posted By snowtaipan
I actually havent closed a deal because I work...

I actually havent closed a deal because I work 80+ hour weeks
Forum: Exterior Parts (Aero, Lighting, Etc.) 08-02-2020, 03:39 PM
Replies: 3
Views: 971
Posted By snowtaipan
SOLD '17 BRZ OEM Taillights

190963
2017 BRZ Series Yellow stock taillights + markers and horn
Tail lights: <1k miles, gaskets still ok ($190 each on Autozone)
Side Markers: <30k miles, still fine ($35 autozone)
Horn: I...
Forum: Engine, Exhaust, Bolt-Ons 08-02-2020, 03:26 PM
Replies: 13
Views: 2,355
Posted By snowtaipan
WTS 17' BRZ Red Intake

190959
190960
OE Red intake: ~40k miles, $150 (El Paso TX) if you pick up or $200 shipped.
Everything in the box included.
Recently added Edelbrock SC, I don't need the old parts. I will be...
Forum: Forced Induction 06-12-2020, 12:56 PM
Replies: 166
Views: 22,944
Posted By snowtaipan
Talking S10C tune update

So I've been using the K00C tune with the MAF scaling from Edelbrock for a while, and had no issues. It looks like it's pushing around 225HP (using an ELM scanner and TORQUEPro app.) The downside is...
Forum: Forced Induction 06-12-2020, 12:34 PM
Replies: 166
Views: 22,944
Posted By snowtaipan
When you say pinching the line solved the issue...

When you say pinching the line solved the issue what do you mean? If you keep that closed at all times, you'll never have boost. That line on the back closes the port in the manifold allowing air to...
Showing results 1 to 30 of 100
Page 1 of 4 1 234

 
Forum Jump

All times are GMT -4. The time now is 02:01 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.