follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 2 1 2
Showing results 1 to 30 of 60
Search took 2.71 seconds. Search: Posts Made By: steved
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 02-17-2024, 01:13 AM
Replies: 14
Views: 1,154
Posted By steved
I had read the SR6 was just a higher thigh...

I had read the SR6 was just a higher thigh bolstered SR7. You mention the SR7 is narrow in the shoulders (narrower than stock?), would you say the same for the SR6?
Forum: BRZ Second-Gen (2022+) -- General Topics 02-15-2024, 09:42 PM
Replies: 134
Views: 24,206
Posted By steved
Racecomp Engineering I saw in another...

Racecomp Engineering

I saw in another thread you mentioned installing the SR7's and gaining 40mm of headroom - do you have another thread where you have your full review / any guidance or can you...
Forum: BRZ Second-Gen (2022+) -- General Topics 07-14-2023, 05:53 PM
Replies: 134
Views: 24,206
Posted By steved
Racecomp Engineering any update on your...

Racecomp Engineering any update on your seats/rails? yes I'm going to keep nagging :)
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-04-2023, 02:34 AM
Replies: 10
Views: 1,268
Posted By steved
https://blog.amsoil.com/dot-3-and-dot-4-brake-flui...

https://blog.amsoil.com/dot-3-and-dot-4-brake-fluid-whats-the-difference/

Mentions dot3 can absorb 2% per year, the more moisture in the brake fluid the lower the boiling point will be. I won't...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-03-2023, 12:37 PM
Replies: 42
Views: 4,143
Posted By steved
'23 BRZ, stock suspension + verus camber plates...

'23 BRZ, stock suspension + verus camber plates in the front:

Left side plate is maxed out, right side has a visible gap:...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-02-2023, 08:16 PM
Replies: 19
Views: 4,164
Posted By steved
From the manual, page 7: So am I...

From the manual, page 7:


So am I understanding correctly, that these coilovers are 1-way adjustable, and that the adjustment is mostly for rebound? Does anyone have the inside scoop on what the...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 05-26-2023, 09:14 PM
Replies: 45
Views: 11,727
Posted By steved
Unfortunately the Camry headrests don't hold true...

Unfortunately the Camry headrests don't hold true for 2022+ seats, the headrest posts are spaced differently than 1st gen.
Forum: BRZ Second-Gen (2022+) -- General Topics 05-15-2023, 10:49 PM
Replies: 27
Views: 4,062
Posted By steved
Can you rip the CDs to a USB key? Seems the head...

Can you rip the CDs to a USB key? Seems the head unit supports lossless compression codecs: www.gr86. org/threads/music-in-the-22-brz.1733/
Forum: BRZ Second-Gen (2022+) -- General Topics 05-06-2023, 12:31 AM
Replies: 134
Views: 24,206
Posted By steved
Pat Have you looked into fix mounting the...

Pat

Have you looked into fix mounting the GT to the planted bracket? Wondering if that's even feasible.
Forum: BRZ Second-Gen (2022+) -- General Topics 05-06-2023, 12:23 AM
Replies: 134
Views: 24,206
Posted By steved
RT-BRZ Thanks for the reply, very helpful -...

RT-BRZ

Thanks for the reply, very helpful - for the sliding restriction, do you see any way to measure the difference to stock seats? Im only 5'11 but have a long torso and like to sit very...
Forum: BRZ Second-Gen (2022+) -- General Topics 05-05-2023, 02:08 PM
Replies: 134
Views: 24,206
Posted By steved
RT-BRZ I noticed in...

RT-BRZ

I noticed in https://www.ft86club.com/forums/showthread.php?t=144534 you installed Braum seats and gained quite a bit of headroom. How have the seats held up over the last couple years? Do...
Forum: BRZ Second-Gen (2022+) -- General Topics 05-04-2023, 01:08 AM
Replies: 134
Views: 24,206
Posted By steved
Racecomp Engineering Any updates on your...

Racecomp Engineering

Any updates on your seats/sliders or ETA?
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-26-2023, 08:25 PM
Replies: 42
Views: 5,362
Posted By steved
Kulebrero Did you follow up?

Kulebrero

Did you follow up?
Forum: BRZ Second-Gen (2022+) -- General Topics 04-10-2023, 12:38 AM
Replies: 134
Views: 24,206
Posted By steved
Racecomp Engineering Kawaii Works T130 or...

Racecomp Engineering

Kawaii Works T130 or T131 brackets? Looks like both are listed for both chassis:
http://www.kawaiworks.com/seatrail_cat/zn6
http://www.kawaiworks.com/seatrail_cat/zn8

Are...
Forum: BRZ Second-Gen (2022+) -- General Topics 04-05-2023, 11:44 AM
Replies: 134
Views: 24,206
Posted By steved
Re_Invention does it seem possible to separate...

Re_Invention does it seem possible to separate the headliner fabric from the shell? I'm thinking if you could, potentially an upholstery shop could offset the cutout, build up the gap, and then wrap...
Forum: Engine Swaps 07-08-2022, 02:45 PM
Replies: 1,756
Views: 240,169
Posted By steved
zuldajin did you make any progress with kpower...

zuldajin did you make any progress with kpower addressing your header welds? I've been contemplating a similar setup as yours since last year but have been worried that Vancouver is missing a lot of...
Forum: Engine Swaps 02-13-2022, 02:02 AM
Replies: 1,756
Views: 240,169
Posted By steved
I don't think that's an accurate representation...

I don't think that's an accurate representation of kmiata/kpower public intent with this kit. From what I remember, and what caught my attention was the premium swap angle, non-race motor mounts,...
Forum: Engine Swaps 09-14-2021, 09:42 PM
Replies: 1,756
Views: 240,169
Posted By steved
Agreed, depends what your redline is, which...

Agreed, depends what your redline is, which tracks you run, or if you're drag racing. Also how much tq your engine makes and where in the rev range it makes it. Too many variables for a catch all...
Forum: Engine Swaps 09-05-2021, 01:56 AM
Replies: 1,756
Views: 240,169
Posted By steved
Not sure where all this is going with the SC FA20...

Not sure where all this is going with the SC FA20 vs F20C but gearing alone didnt make the FRS look bad, it's the gearing + a 9k redline that did the trick. If you can keep pulling in 2nd gear for...
Forum: Engine Swaps 08-21-2021, 11:04 PM
Replies: 1,756
Views: 240,169
Posted By steved
Sign up for their mailing list, they're supposed...

Sign up for their mailing list, they're supposed to release the kit within the next couple weeks and will notify list members.
Forum: Engine Swaps 08-21-2021, 07:40 PM
Replies: 1,756
Views: 240,169
Posted By steved
ML I think you were trying to track down a rotrex...

ML I think you were trying to track down a rotrex mounting bracket for the k24 a/c compressor location, did you have any luck finding a company that would sell it without a kit?
Forum: Forced Induction 07-06-2021, 05:24 PM
Replies: 6,004
Views: 2,052,537
Posted By steved
Just cracked my 2013 OEM header, currently on a...

Just cracked my 2013 OEM header, currently on a C38 kit/CARB tune and having a really hard time finding a used 13-16 header locally.

I did find a 2017 header, but just want to confirm my thoughts...
Forum: Engine, Exhaust, Transmission 06-28-2021, 01:20 AM
Replies: 5
Views: 1,282
Posted By steved
Push the clutch in slightly in neutral sitting...

Push the clutch in slightly in neutral sitting still, does the sound go away?
Forum: Engine Swaps 06-19-2021, 08:31 PM
Replies: 472
Views: 89,076
Posted By steved
I had the dual rad on my carb tuned jrsc kit and...

I had the dual rad on my carb tuned jrsc kit and had terrible overheating issues at the track.

Upgraded to the standalone oil cooler kit and had a significant improvement but still hit over 265F...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 06-09-2021, 02:47 AM
Replies: 1
Views: 2,030
Posted By steved
Andyxin did you gain any head/helmet room with...

Andyxin did you gain any head/helmet room with this seat combination over stock seats?
Forum: Engine Swaps 10-29-2020, 11:36 PM
Replies: 20
Views: 6,284
Posted By steved
Any reason not to include the haltech 1500?

Any reason not to include the haltech 1500?
Forum: Engine Swaps 10-22-2020, 01:13 AM
Replies: 20
Views: 6,284
Posted By steved
A bit pessimistic.. kmiata/kpower is working on a...

A bit pessimistic.. kmiata/kpower is working on a swap kit.....
Forum: DIY (Do-It-Yourself) Guides 05-28-2020, 12:25 AM
Replies: 1
Views: 4,365
Posted By steved
Mr. you were able to use the oem bolts to bolt...

Mr. you were able to use the oem bolts to bolt the front bar back up to the chassis? I just tried to mount the bar up tonight for mock up and couldn't get the top threads to catch. I think the bar...
Forum: Forced Induction 04-12-2020, 01:03 PM
Replies: 6,004
Views: 2,052,537
Posted By steved
So here the question is focused on going from 200...

So here the question is focused on going from 200 to 300 hp. This would infer standard kit install, factory or diy tune should be pretty similar in power if all else is equal:



But then hood...
Forum: Forced Induction 04-12-2020, 02:34 AM
Replies: 6,004
Views: 2,052,537
Posted By steved
If the all caps wasn't originally enough I'll add...

If the all caps wasn't originally enough I'll add bold to emphasize my question:


If it's tested OK, why would the hood vent be necessary?
Showing results 1 to 30 of 60
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 04:12 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.