follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 25 of 25
Search took 1.67 seconds.
Search: Posts Made By: saikat.saha
Forum: Software Tuning 04-05-2019, 02:38 AM
Replies: 4
Views: 1,090
Posted By saikat.saha
Thanks . You are right. It was a one way...

Thanks .

You are right. It was a one way check valve problem in the boost gauge line. Thats why boost was leaking . Not it’s soleved .
Forum: Software Tuning 04-03-2019, 07:48 AM
Replies: 4
Views: 1,090
Posted By saikat.saha
Manifold pressure shows 1.7 bar with full...

Manifold pressure shows 1.7 bar with full throttle by ecutek datalog.

When ignition on and engine off it shows 1 bar.

When idle it shows.7 bar as turbo has factory spring .

I am using a ebc...
Forum: Software Tuning 04-03-2019, 01:39 AM
Replies: 4
Views: 1,090
Posted By saikat.saha
Boost Gauge reading low

Hi guys,

I am running 10psi on Greddy T518z according to my tumer report. But in boost Gauge it’s showing 5psi. 2 or 3 days ago it was okay. Suddenly it starts to showing 5psi constantly from 3k...
Forum: Forced Induction 09-01-2018, 05:32 PM
Replies: 124
Views: 95,373
Posted By saikat.saha
Hello friends, I am using greddy T518z on my...

Hello friends,

I am using greddy T518z on my gt86 . It doesn't comes with boost controller, i am planning to increase the boost by grimmspeed ebcs than the factory map with 7psi . But I couldn't...
Forum: Forced Induction 09-01-2018, 05:23 PM
Replies: 17
Views: 16,768
Posted By saikat.saha
Hello my friend, I am using greddy T518z on...

Hello my friend,

I am using greddy T518z on my greddy t518z. It doesn't comes with boost controller, i am planning to increase the boost by grimmspeed ebcs than the factory map with 7psi . But I...
Forum: Forced Induction 08-19-2018, 05:17 PM
Replies: 19
Views: 7,890
Posted By saikat.saha
Stock Injectors and fuel pump ??

Stock Injectors and fuel pump ??
Forum: Engine, Exhaust, Transmission 08-01-2018, 02:49 AM
Replies: 59
Views: 21,769
Posted By saikat.saha
Hello guys, I am not expert. Need your help...

Hello guys,

I am not expert. Need your help guys. I bought used 2013 gt86 . Got exedy satge 1 clutch on it. Throwout bearing noise increased so much. I am confused that 1 clutch has different...
Forum: Forced Induction 05-06-2018, 06:07 AM
Replies: 1,048
Views: 429,071
Posted By saikat.saha
hey andrew, i have sent you req on instagram, i...

hey andrew, i have sent you req on instagram, i wanna see the tial bov on the sc kit, i also might have a few questions about it.
Forum: Forced Induction 04-23-2018, 03:34 AM
Replies: 1,048
Views: 429,071
Posted By saikat.saha
My V2 came with the HKS Flash Editor, so i used...

My V2 came with the HKS Flash Editor, so i used that to flash my ecu after the setup. Now i am thinking to getting a replaced ecu and flashing it with delicious tune. do you think this will be a...
Forum: Software Tuning 03-15-2018, 06:16 PM
Replies: 4
Views: 2,359
Posted By saikat.saha
Hello, Need oft custom tuner , who can tune...

Hello,
Need oft custom tuner , who can tune overseas, i am from bangladesh.
I got OFT for tuning.
Toyota gt86 2013
Greddy T518z turbo setup.
3 bar map sensor
Stock injector and stock fuel pump....
Forum: Software Tuning 03-15-2018, 05:45 PM
Replies: 158
Views: 132,025
Posted By saikat.saha
Hello, Need oft custom tuner , who can tune...

Hello,
Need oft custom tuner , who can tune overseas, i am from bangladesh.
I got OFT for tuning.
Toyota gt86 2013
Greddy T518z turbo setup.
3 bar map sensor
Stock injector and stock fuel pump....
Forum: Software Tuning 03-11-2018, 05:54 AM
Replies: 140
Views: 265,194
Posted By saikat.saha
Hello all, I am from bangladesh. My 86 has...

Hello all,

I am from bangladesh.
My 86 has Greddy T518z Turbo kit installed and tuned by Greddy. To tune again i have to install new ecu because previous ecu is locked by previous tuner.

I...
Forum: Software Tuning 03-11-2018, 04:21 AM
Replies: 110
Views: 72,040
Posted By saikat.saha
Hello all, My 86 has Greddy T518z Turbo kit...

Hello all,
My 86 has Greddy T518z Turbo kit installed and tuned by Greddy. To tune again i have to install new ecu because previous ecu is locked by previous tuner.
I have replaced my ecu with a...
Forum: Software Tuning 03-10-2018, 12:26 PM
Replies: 110
Views: 72,040
Posted By saikat.saha
Hello all, I have replaced my ecu with a used...

Hello all,
I have replaced my ecu with a used one which one i bought. After looping 3 and 14 pin of the obd port and pressing 2 times the start button, CEL loght start blinking. I have waited for 30...
Forum: Engine, Exhaust, Transmission 08-29-2017, 09:20 AM
Replies: 11
Views: 2,575
Posted By saikat.saha
Noy very much as i bought it as used car from...

Noy very much as i bought it as used car from japan. It got stage 1 clutch plate installed.
Forum: Engine, Exhaust, Transmission 08-29-2017, 09:18 AM
Replies: 11
Views: 2,575
Posted By saikat.saha
Closer to the top of the travel . Sorry for my...

Closer to the top of the travel .
Sorry for my late reply.
Forum: Engine, Exhaust, Transmission 08-26-2017, 03:33 PM
Replies: 11
Views: 2,575
Posted By saikat.saha
You are right. Upshift near redline should be...

You are right. Upshift near redline should be easy. But i could not figure out why its happening.
Forum: Engine, Exhaust, Transmission 08-26-2017, 05:47 AM
Replies: 11
Views: 2,575
Posted By saikat.saha
Hard to shift at High RPM (above 7K)

Hello all,

Before I begin, I bought GT86 from japan , model year - 2013 with Greddy T818z Set up. I don't know if the upcoming description is normal.

When I try to shift from 1 to 2, 2 to 3, 3...
Forum: Issues | Warranty | Recalls / TSB 08-26-2017, 05:44 AM
Replies: 45
Views: 24,450
Posted By saikat.saha
Hello all, Before I begin, I bought GT86...

Hello all,

Before I begin, I bought GT86 from japan , model year - 2013 with Greddy T818z Set up. I don't know if the upcoming description is normal.

When I try to shift from 1 to 2, 2 to 3, 3...
Forum: Software Tuning 03-29-2017, 09:28 AM
Replies: 110
Views: 72,040
Posted By saikat.saha
Hi, I am new here. sorry if i ask any wrong...

Hi,

I am new here. sorry if i ask any wrong question.I have Toyota GT86 2012 car. Bought it from japan , it got Greddy T518z turbo setup and tuned the ECU by Greddy and locked.
Code - ZA1JA01A...
Forum: Software Tuning 03-29-2017, 09:06 AM
Replies: 13
Views: 6,417
Posted By saikat.saha
Hi, I have Toyota GT86 2012 car. Bought it...

Hi,

I have Toyota GT86 2012 car. Bought it from japan , it got Greddy T518z turbo setup and tuned the ECU by Greddy and locked.
Code - ZA1JA01A
I need to Reflash the ECU and back it on stock ROM...
Forum: Software Tuning 03-29-2017, 09:03 AM
Replies: 13
Views: 6,417
Posted By saikat.saha
Hi, I have Toyota GT86 2012 car. Bought it...

Hi,

I have Toyota GT86 2012 car. Bought it from japan , it got Greddy T518z turbo setup and tuned the ECU by Greddy and locked.
Code - ZA1JA01A
I need to Reflash the ECU and back it on stock ROM...
Forum: Forced Induction 03-29-2017, 04:08 AM
Replies: 124
Views: 95,373
Posted By saikat.saha
Hi Guys, My Gt86 running on T518z turbo kit on...

Hi Guys,
My Gt86 running on T518z turbo kit on pump gas. Recently i saw temperature showing on meter board is 49 degree Celsius. Is it normal. i was driving for one hour. Any suggestion about this...
Forum: Software Tuning 02-14-2017, 12:49 AM
Replies: 8
Views: 2,726
Posted By saikat.saha
Hello there, I am from Bangladesh , my GT86...

Hello there,

I am from Bangladesh , my GT86 bought from Japan with Greddy T518z Turbo Kit and tuned the ECU by Greddy.

Now i am facing problem with greddy tuned because our country does not...
Forum: ASIA 02-14-2017, 12:42 AM
Replies: 0
Views: 3,982
Posted By saikat.saha
Greddy Tuned ECU

Hello there,

I am from Bangladesh , my GT86 bought from Japan with Greddy T518z Turbo Kit and tuned the ECU by Greddy.

Now i am facing problem with greddy tuned because our country does not...
Showing results 1 to 25 of 25

 
Forum Jump

All times are GMT -4. The time now is 01:39 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.