Pete39sp from instagram

Awesome build! I used to be a massive Sonic fan when I was a kid, so massive props for the Shadow inspired theme :thumbsup:

Got my emblems installed! Also installed my Valenti TapTurn module.

http://www.ft86club.com/forums/pictu...ictureid=10464

Just dropped the car off at Jacks Transmission in Colorado Springs. Having my transmission mount, clutch fork, and pivot installed along with my PAR gear set. Superexcited for this to get done, will post some pictures later on. Then once i get around 1,000 miles on the trans i will flush it with neo synthetic and install my carbon fiber driveshaft.

They got the trans out and are working on taking the trans apart now.


http://www.ft86club.com/forums/pictu...ictureid=10511


http://www.ft86club.com/forums/pictu...ictureid=10510

Got more shots from Jacks Transmissions today.


http://www.ft86club.com/forums/pictu...ictureid=10518


http://www.ft86club.com/forums/pictu...ictureid=10519


http://www.ft86club.com/forums/pictu...ictureid=10520


http://www.ft86club.com/forums/pictu...ictureid=10521

[ame="https://www.youtube.com/watch?v=vOhhHN3_lcU&feature=share"]Audio - PAR straight cut gearset in 2015 Subaru BRZ - YouTube[/ame]

I just put in my order for my diff to be rebuilt with the 3.73 final drive and a Supra bearing and solid spacer. Should hold up nice to the power im looking to make, and if not then I will just go another route later on. Will probably order my axles by November and then get those installed. Going to start really ramping up the closer I get to May when I send the car in for the motor rebuild with Turbo kit install.

Installed my Carbon Fiber Driveshaft and swapped over to Neo Synthetic RHD gear oil in the transmission with the new PAR gear set.


http://www.ft86club.com/forums/pictu...ictureid=10547


http://www.ft86club.com/forums/pictu...ictureid=10546


http://www.ft86club.com/forums/pictu...ictureid=10545


http://www.ft86club.com/forums/pictu...ictureid=10544

[ame="https://www.youtube.com/watch?v=eeggjO0Wf6g"]Par gearset 1st thru 6th pull in a BRZ - YouTube[/ame]

That gear whine would get annoying after a five minute drive. Why did you upgrade the gear set?

It's actually not that bad. I dont even notice it anymore with music playing. I upgraded the transmission because if you read the beginning of my build thread this car is planned to have the motor built and turbo installed. The stock transmission would have imploded.

Just an update, my diff should be done in about 3 weeks from Spencer's fabrication Co. Also ordered a Harrop Diff cover for it that will be installed as well. November is when I will probably order the axles, and then get all of it installed.

Awesome progress!


I want a PAR gear and built motor next!