Ok. Thank you so much. I'll pm you if I still get error tomorrow.

Worse comes to worse though and it still doesn't work I'd worry that because the car can't start your battery voltage is rapidly dropping every time you try to crank. That means you may need to go to a dealer and try and get something warranty repaired

Yes that's what I'm worry about. I don't want go to dealer. That's to much work for me. The car can't start, I'll need towing and they are close tomorrow.

In this situation where you have problems best to flash original stock rom stored in OFT called "Original File" this is your original stock rom stored by oft. This may allow oft to flash over corrupted rom.

I have done this with Tactrix but not OFT

I'll try this later. I may buy a tactrix if oft still doesn't work. I tried to flash back to original file many times yesterday but oft still shows error.

That sucks dude, what about the flash over to stage 1 or stage 2?

Always show me error. Every times. Sounds like out of battery when I start the car, just 1 sec with that sound.

Do you still have the 2 or 3 year roadside assistance? You might need to call em up and have em transport to the dealer even though it's Sunday they'll do it.

I don't have it. I only have the Subaru gold warranty. But I think it will cover it.

Worse comes to worse in the diagnosis don't say you did anything related to tuning and such, also you might want to put the OEM headers back on. Depending on the dealer they will definitely invalidate the warranty if that stuff is left on there and they notice the ecu calibration stuff is all messed up. Just say it didn't start in the morning and earlier on it was running quite rough.

Yes, I think I need to put the oem header back on if I still can't flash stock rom into ECU today. Then go to dealer.

make sure battery is charged, oft will not flash if volts too low.

Hope it just low volts. I'm gonna find a charging cable.

happens to me all the time. what i do is unplug oft and then plug it back in to flash.