Plasti Dip Emblems
 

this stuff works great!

cheap, no mess, no prepping needed

just spray and go!

when you're tired of it, just peel it

http://i1053.photobucket.com/albums/...6/a36c78c2.jpg


before

http://i1053.photobucket.com/albums/...6/64b732ff.jpg

http://i1053.photobucket.com/albums/...6/7571e3ac.jpg


after

http://i1053.photobucket.com/albums/...6/32f30acd.jpg

http://i1053.photobucket.com/albums/...6/11eaa7de.jpg

http://i1053.photobucket.com/albums/...6/d3633e3b.jpg

I agree...

http://www.ft86club.com/forums/garag...11387/1245.jpg

looking good guys!

thanks!

ill be playing with the wheels next.

just want to see how black on black looks haha!

Please do! I have black and white... but I feel white will just be too dirty and might look rice.

Here's how red turned out on my stock wheels. I kinda like it.

http://www.ft86club.com/forums/garag...11387/1244.jpg

Great work! This is on my to-do list. I already have the spray, just trying to decide if I want to do the Scion logos or get the Toyota ones.

I had also considered doing the BeatSonic Shark Fin in flat black but got talked out of it by MomHawk.

Do like, did you pinstripe it or what did you use?

How durable is this stuff?

:barf:

I don't like the Toyota emblem at all, but it looks so much better black.

I've been thinking about Plasti-dipping the stock wheels as well as the silver colored bezels around the radio and passenger side. As seen in the following video, it seems fairly easy!

[ame="http://www.youtube.com/watch?v=zwUuFUbulw8"]How to Plasti-Dip Rims - YouTube[/ame]

It just red plastidip... taped it off got to work. had to do it in all one thick coat otherwise the tape will pull off the dip when its dry.

The pics I posted above are all plastidip. If you use it.. just be patient.. put on thin coats and let them dry like the video says.

If you have to tape something off (see my wheel photo above) then you kinda have to do something small and one thick coat and then pull off the tape before it dries.. it's a pain but if done right gives good results..

Here's an example of doing things on the dash... I'm going to peel it and re-coat it though because One side didn't come out like I liked and I had to use a 2nd can and the color wasn't a perfect match... but here it is:

http://www.ft86club.com/forums/garag...11387/1257.jpg