3" axleback to 2.5" mid pipe
 

Just picked up a Nameless 3" axleback. I ordered the right gasket from the Nameless website but it won't come in until next week. Can I reuse the stock gasket and hardware until then?

You can use the same hangars.

The old gasket should fit; I don't recall a new gasket coming with mine.

But, you might call Nameless just to make sure.

360-263-5001


humfrz

Is yours the 2.5" or 3" axleback?

I guess I'll find out in the morning lol. . .

Mine is a 2.5" axle back with 5" mufflers.

It would seem that either the 3" or the 2.5" would hook up the stock mid-pipe with the same gasket.

However, best to check with Nameless, as I'm not sure how it is necked down.


humfrz

Alright well, went ahead and tackled it this morning. Took about 10 mins total with an extra set of hands. The gasket didn't line up completely so I'll have to redo it when the gasket I ordered from Namelss comes in next week.

Told my buddy to rev it to 5k but it he took it to redline lol. . . there was a high pitch sound that came out, im assuming it was from the stock gasket not lining up. I didn't hear it while actually driving though. Completely satisfied with the sound :thumbup:

Video after install in my Instagram if interested: Ayoo_Adriannn

Nameless 3"axle-back with 5" mufflers.
http://i754.photobucket.com/albums/x...psaklbhmjr.jpg

Compared to stock. Per website axle-back is ~17lbs while stock is ~25lbs
http://i754.photobucket.com/albums/x...pssc8uw2qf.jpg

Good show! Nice pictures...... :thumbsup:


humfrz