Oil catch can for Normally Aspirated cars
 

Yesterday I looked inside my throttle body and there was a decent amount of oil deposit on the inside.

Even though the engine is stock, it appears as if a catch can would be helpful.

Anybody here can share their catch can installation setup and results, on normally aspirated card ?

http://www.newegg.com/Product/Produc...0023-_-Product

Great can, works well. Can be left closed loop for N/A, or open with the filter if you go boost.

Used a clip like this one to attach it to my strut bar
http://www.homedepot.com/p/Unbranded...insulated+clip

Went to autozone and bought 18in of 3/8 and i think 11/32 rubber tubing

I'm using the mishimoto catch can on my NA frs and it's working as intended. Check their build thread for it

Here's my Radium can routed for the PCV valve (the more important one since you're NA) I catch stuff in there after spirited drives, mostly after autocross. It's a good peace of mind mod. Radium now has a specific kit for our car as well, and their cans are highly recommended by myself and others on this forum.

http://www.ft86club.com/forums/showp...&postcount=161

I have the Mishimoto oil catch can on the PCV valve and it had only a few drops of oil after 4 track days. So for a healthy N/A engine its not a requirement but definitely nice to have if you are going to track the car on a regular basis.

I use this:
http://www.moroso.com/eb/catalog/nav...ge%20Body.html

They also make a drain cup that works great with the separator.

http://www.moroso.com/eb/catalog/nav...ain%20Cup.html

After 3 20min sessions, I can get about half cup of oil from it.