|
Camshaft Teaser...
Not much to say yet, we just had these ground to our specs for testing. We're a couple months out on testing at this point but it's exciting none the less.
https://scontent-iad3-1.xx.fbcdn.net...13104690_o.jpg For anyone wondering about what's going on with our shop car, here's a hint... https://scontent-iad3-1.xx.fbcdn.net...13853060_o.jpg |
:O the more the merrier, cant wait for results
Sent from my SM-G850W using Tapatalk |
Quote:
You guys are looking for a welder? |
Quote:
|
it was a joke. You said: For anyone wondering about what's going on with our shop car, here's a hint...
and a picture of a unfinished cage and welder equipment followed. :P |
So I hope you check the cams against the specs while in the heads before bolting the whole thing up and putting her on the dyno. Have had bad cam grinding done. It makes power....but horrible grind and not what was spec'd.
|
Yes, of course they will be checked. Nothing like tossing in a set of cams and guessing!
There are other valvetrain parts in development, but we haven't release them yet. (to go along with the installation of these camshafts) |
Quote:
|
| All times are GMT -4. The time now is 10:23 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.