Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB

Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB (https://www.ft86club.com/forums/index.php)
-   CANADA (https://www.ft86club.com/forums/forumdisplay.php?f=19)
-   -   iGarage Markham supercharger install review (https://www.ft86club.com/forums/showthread.php?t=89247)

wbradley 05-30-2015 05:57 PM

iGarage Markham supercharger install review
 
I was fortunate enough to pick up an HKS GT V1 supercharger kit with Stg 3 upgrades recently from the brother of the owner of Alpha Motorsports. They were a pleasure to deal with BTW and I will send any business I can their way. As a warehouse/online operation it is best to call or email them before dropping in as there's no showroom. They are pretty low key but they do have stuff for the twins in stock...including Swift springs!! Anyway, this was a swap from Alpha's Rocket Bunny BRZ to my FR-S and they recommended iGarage as they did the original install. Ivan, the boss at iGarage was reasonable and slotted me in within less than a week from when I called. He is a friendly guy and seems to get a ton of Subies in his shop. The car went in on Thursday morning and was ready to go by Fri evening. This was both a removal and an install. I am very satisfied with the job and would recommend Ivan for anything from a header install, FI install, brakes, etc. He has a guy there that works on projects so they get worked on continuously until done. The shop is small but they can do whatever you need reasonably. I had heard a member say he will install headers for $50. That sounded a bit far fetched but they did do a great job for me. Recommended!

FRSCanuck 05-30-2015 06:07 PM

Great review!

Have you decided what route your going to take with regards to the tune?

wbradley 05-30-2015 06:23 PM

Quote:

Originally Posted by FRSCanuck (Post 2268269)
Great review!

Have you decided what route your going to take with regards to the tune?

I have an appointment with Sasha @ Onpoint in 2 weeks. On the donor BRZ the dyno chart shows peak wheel HP at 244. Thats pretty close to 300 at the crank. I should be pretty equal with my current setup. In the meantime I am using the HKS ECU module which is extremely conservative. I will decide later whether to install the smaller pulley/upgraded fuelling as I am not quite prepared to upgrade the clutch or internals at this point.

Mr.Impreza 05-30-2015 07:23 PM

Sweet, I must of brought in good lucky that day haha :p

Going to be a crazy car now for sure!!!

Myv 05-30-2015 08:45 PM

Saw you this morning, and your car sounds amazing when you cranked her up :) have fun with the new boost! Super nice under the hood ;)

wbradley 05-30-2015 08:49 PM

Quote:

Originally Posted by Myv (Post 2268382)
Saw you this morning, and your car sounds amazing when you cranked her up :) have fun with the new boost! Super nice under the hood ;)

Thank you and nice meeting you today. I hope you got your exhaust gasket taken care of.

botbs 05-30-2015 09:34 PM

Quote:

Originally Posted by wbradley (Post 2268284)
I have an appointment with Sasha @ Onpoint in 2 weeks. On the donor BRZ the dyno chart shows peak wheel HP at 244. Thats pretty close to 300 at the crank. I should be pretty equal with my current setup. In the meantime I am using the HKS ECU module which is extremely conservative. I will decide later whether to install the smaller pulley/upgraded fuelling as I am not quite prepared to upgrade the clutch or internals at this point.

Would you mind telling me more information about the HKS ECU module?

Is it this one? I thought it only works for JDM cars only. Thanks!
http://www.hks-power.co.jp/product_d...1at009_p05.jpg

wbradley 05-30-2015 09:45 PM

Quote:

Originally Posted by botbs (Post 2268421)
Would you mind telling me more information about the HKS ECU module?

Is it this one? I thought it only works for JDM cars only. Thanks!
http://www.hks-power.co.jp/product_d...1at009_p05.jpg

You are correct, the module pictured is something similar to the OFT and is only sold in Japan. My kit included an F-Con iS, which pigtails to the car's ECU with its own wiring harness and controls the engine management. The resident base tune, which is very conservative, can only be edited by an HKS certified tuner using their proprietary software. I am not sure if anybody in Canada does it thought there is one company in Calgary that says they do on their website. They are also Dinan tuners. If you Google it you will see the box. Most HKS kits sold are "pro kits", so no tune included. Makes it kinda difficult as car cannot be driven to the tuner after the hardware install.


All times are GMT -4. The time now is 02:02 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.


Garage vBulletin Plugins by Drive Thru Online, Inc.