Mod barging duck bill
 

Anyone know how to install mod barging CF duck bill? What should I do to make it fit the trunk. Sand it? mold it with bondo? Thanks guy, and also it would be great if you guys can give me a short step by step.

I believe all you need to do is get some double sided tape and slap it on. check fitment first though before you tape it down.

Yeah, I got the tape but fitment isn't good. Bunch of gaps and holes not flush.

With CF most peices are usually sanded a bit to fit. They shouldn't be that far off

Hmm OK thanks I'm check it out. So would you sand all the bumps that stick up a bit on the bottom down? To make it flat with the rest of the bottom of the wing.

If it were me I would start with the biggest. Test fit. Then sand again. Test fit. And repeat as needed. But I would try to pm @Shutter; as he has dealt with this product directly if I remember right.

Haha OK thanks big help.

exactly what you need to do!

Use blue tape on the trunk too so it doesnt get scratched during test fits.

Start with drilling before test fitting then riveting. Double sided gorilla glue to make sure any gaps are filled.
I'm completely joking and do as above.

At first I was like serious? Haha until I got to the end.

The edges seems thin, what side/place requires the most sanding for you guys.

Where can I order one of these ? I can't find it on their site

Give me a sec, let me get a link for you