Pulling FRS Rear Fenders
 

Hello Everyone,

I just finished installing and aligning my new wheels for my car. The Wheel specs are 18x9 ET30 on 265/35/18 Michelin PSS.

When they were first test fitted:

http://i214.photobucket.com/albums/c...psp8o62bok.jpg

My friend's alignment shop said I definitely needed to raise the front and rear with this new tire set up. So far, the front has no rubbing but the rear is a different story. Car currently has -3 degrees of camber all around.

The guys at my alignment shop say they wouldn't pull the fenders because of the crease our fenders have from the factory fender roll. I took it to another friend of mine who pulls and he says that there will be cracked paint for sure if he tried to pull them.

Who's had the balls to do it? What advice would you give on getting these done?

After being raised:

http://i214.photobucket.com/albums/c...ps84t7ush4.jpg

http://i214.photobucket.com/albums/c...pszvqchdh3.jpg