Header, Overpipe, Straight pipe, Cat back Diameter options/ Combos
 

Hi,

Can anyone provide advice or a link to decent Header / Over pipe / Front pipe and Catback Diameter combo's?

I don't know much about exhaust set up's, but I do know that you should try to keep the diameter consistent to prevent power loss,

Will the different sizes even matter?

Reason being is that I have the following:

-Borla UEL Header which I believe is 2.25inch's /57mm

-Stock overpipe (2.25inchs / 57mm I believe ?)

-De Graaf Straight pipe + De Graaf Cat Back 2.5inch's(63mm)
South African manufactured performance exhaust.
http://www.ft86club.com/forums/showthread.php?t=71718

-Tune

I am in the market to purchase an overpipe.

Of a budget of $200...

Tomei Over pipe (Diameter? The website shows "60")
Invidia (Diameter?)
Private Label MFG (2.5inches / 63mm)

Any opinions ? or recommendations to compliment the Borla UEL and a 63mm straight pipe and catback?

Thanks

Cattless header for power....with tune. Cat back for sound. Done... Everything else is a waste of money till you get to the high end.

This makes me wonder what a Revworks/Tomei UEL and Invidia OP, FP, and N1 would sound like together....unresonated or resonated....hrmmmm

Go resonated. Sounds amazing, but drones. Deep like a WRX pre 2015. No resonator will give you rasp.