How to do a Gauge Pod Install for Rexpeed
 

Hey guys just wondering if anyone has installed the Rexpeed guage pod on their twin, if u did how exactly do u do it ? Wiring and drilling and installing the gauge into the molds

http://www.ft86speedfactory.com/rexp...051de813c9d14a

I'm thinkin that if it's not in the DIY tread, then possibly not.

Looks fairly straightforward. Pop out old piece, wire up new gauges, and pop in new piece

it says right on the page: "Gauge pod goes over factory pillars and are secured with adhesives."

Aka, it will be double sided tape.

No I understand that but how do I wire the guages does it go under this piece and out the side panel where the steering wheel is idk

Did you ever figure this bad boy out, im trying to connect power to a guage but not sure where to tap for 12V ign and dimmer? Thanks