DIY Fog light overlays!
 

I purchased yellow pre cut foglight overlays from www.tctwraps.com for only $9.99 and love them. It took me about 30 minutes to install, it was fun and turned out great! What do you guys think?

1) Prep the fog lights with alc/water and a towel.

2) Pull off one of the pre cut films from its backing paper, and apply it onto the fog light (I did not remove my fogs or anything for the install)

3) Use your finger to press down on the film working it from the center out. It helps to use a heat gun (or hair dryer) I used my wife's hair dryer because I don't have a heat gun. worked perfectly fine.

4) Once everything is covered thats need to be, trim the excess off with a xacto knife. Done that is it.

(If you get a wrinkle, dont worry it is not ruined. pull back to where the wrinkle was and give it a little bit of heat and it will dissipate)

http://www.tctwraps.com/#!tail-light...ght-tint/c1x4h