Chargespeed overfenders / widebody
 

http://www.chargespeed.com/english/zn6-b-1-e1.htm
http://www.chargespeed.com/english/zn6-bottom-3-e1.htm

Anyone know anything about the install of these curious if any body modification is needed since that will make my car illegal in kangaroo land.

It's more a subjective thing but i like them, and RB is out of the question since illegal. so 20mm wide suits me. And yeh im not a fan of the paint matched one either.

I was wondering how simple fender flares would look on our cars, doesnt look too bad just needs be slightly modified to flow with the car a tiny bit better

Don't do it.

Get a 5:AD kit with a RB v2 Duck Bill spoiler instead LOLLLL

So back to my original question anyone know if body mod is required?

Side markers will be covered, and to do flares properly you'll be cutting into your fenders.

Sides can be relocated, i found some close up pictures and it looks like no cutting required, sent an email to chargespeed as well.

Cutting won't be required to install them, but if you want to run wheel offsets to fill them out then you'll need to cut the fender or you'll rub on it like crazy.

Where are you going to relocate it?

if you're not going to cut the stock fenders when putting wider overfenders on, what's the point of even having wide overfenders??? LOL. it'll end up looking like a FRS dune buggy