Yes.

Depends on the version you are on and when was the last time we did an update on the tune. Reach out to sales@delicioustuning.com for more info.

Usually remote tuning is not needed anymore, unless you have a customized setup. But you can reach out to sales@delicioustuning.com for more information, as we do not check here to often.

Updates: Flash & Go and All FI application tunes.
We have made quite a few changes (see list below) to our latest version of the Flash & Go tune which will also include, Edelbrock, Harrop, Innovate, and Jackson supercharger kits.

Please note: we seem to have found a small bug within the latest (and previous versions), while on speed density only, that in certain conditions (warm engine, not hot, not cold) on some 86's (does not affect all vehicles), the vehicle will start and die. This is something we have been reviewing with EcuTek and a few cars that have the issue. Otherwise the idle control should be a bit more stable now when running 100% Speed Density, with a lot less likely chance of receiving a high idle code as in previous versions of the tune.

Latest revisions offered by Delicious Tuning:

Flash & Go (all forced induction applications) Version 33.50
- 100% Speed Density Enabled
- Low speed acceleration from a dead stop.
- Low speed stock throttle, with Race Throttle or higher speeds.
- Improved Direct (mid RPM range) and Port Angle injection (low speeds)
- Improved CAM Angles (better top end power)
- Better tip in response for Speed Density
- Improved off throttle burble (add-on)
- Improved Flex Fuel (Ethanol) performance output
- Improved Idle Control for more applications
- Improved Mid Throttle / Mid RPM response and AFR ratios/targets
- More Details: Click Here

Regards,
William Knose
Delicious Tuning

nice
 

works like a charm