anybody do a rocket bunny V1 diffuser install?
 

i just bought a Rocket bunny v1 rear diffuser and i understand that you have to cut the stock reverse light out to make it fit. I am a little confused about how it fastens to the stock bumper cover. Double sided tape plus rivets?
if any one has any input on this or any pics on an install please share .

Other than cutting the reverse light you will also have to drill where the top 3 bolts go on the diffuser and on the sides of the bumper (2 holes for each side). No double sided tape, maybe rivets but I suggest lock nuts and bolts.

Thanks man I'm trying to find some nice looking hardware to replace the rivets.

Allen key bolts, they look good on everything.

You are the man. I knew what they were just not what they were called. Thanks for your help. :thanks:

You're welcome, good luck.

Hey quick question or maybe you can link me to it. How did you wire up your reverse light I don't wanna start cutting wires without knowing someone has done it the same before. Thanks in advance

If I do recall properly, take off the stock reverse lamp, cut the insulation on the reverse lamp wire, wire the LED reverse light into the stock reverse lamp wire, electric tape wherever you mated the two wires together, voila.

I am very interested in this install as I have been looking at getting this for my car. Can you do me a favor and take a picture of it on the ground before you install it. And of course pictures of the install.