tomei El header fitment
 

Fits up perfectly with the invidia up pipe. Only thing I had a little issue was on the driver side of the header. You can't really get a ratxhet on one of the bolts so you have to feed an extension through the space of the piping and have a socket already in place on the bolt. It won't fully seat, but it'll get enough to where you can turn it. Sounds pretty good with the catless front pipe and trd exhaust

sound clips?

Any chance you're getting it dyno tuned? I'm still waiting on the full results from this header until I pull the trigger. It seems promising, but hardly any potential of most aftermarket headers is seen prior to having a proper tune done

dyno tune probably not but i have the oft tablet

Go get a baseline dyno run done! Haha I want to see dyno results to compare to other headers.. untuned dyno results from headers are pointless imo, but since you have an OFT, you still have some sort of tune to show gains

+1

Been too lazy for sound clips lol. I'll try and get one this weekend

I installed my tomei uel today! Fits perfect! I have a leak somewhere cause I couldn't get the socket even with a ujoint... Might need to check it again such a hassle though!
I had a catless front pipe and one resonator in the mid pipe everything else is straight piped and it was so loud.. dare I say too loud? So I threw back my stock front pipe and its perfect. Might change it up again tho! I might throw up some pics and video if I have time