Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB
Page 4 of 6 123 4 56
Show 40 post(s) from this thread on one page

Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB (https://www.ft86club.com/forums/index.php)
-   Engine, Exhaust, Transmission (https://www.ft86club.com/forums/forumdisplay.php?f=8)
-   -   Header+front/overpipe(stock catback) enter yours (https://www.ft86club.com/forums/showthread.php?t=72645)

s2d4 11-10-2014 12:39 PM
Quote:
Originally Posted by Wayno (Post 2016659)
Well if you have no cats on a street car you're a douche, end of story, even on e85.
I do have a cat actually, only the header is aftermarket.
And yeah, E85 will pass sniffer tests without a cat.
No sure why you are calling me a douche. Thanks anyway.

Maverickgear 11-13-2014 08:27 PM
Quote:
Originally Posted by edeekeos (Post 2016625)
Specs in sig(stock catback.) Sounds alot deeper in person, this was taken with my iPhone..

Subaru BRZ Tomei UEL Header - YouTube
I love your setup! Sounds really great! What's contributing to the popping sound though?

FirestormFRS 11-13-2014 09:21 PM
Quote:
Originally Posted by s30series (Post 2016841)
So I guess people that daily drive older classic cars are all douches?

Thanks for letting me know! I was confused for a little bit.:thumbdown:

Maybe you should try coming to a FREE COUNTRY where I can do what I want to my car and not have to worry about my overreaching government telling me what I can and cannot do to my choice of wheels.......pending on state of residence of course lol :popcorn:
last line was sarcasm for those that didn't pick up on it
According to various parts of Section 203, all aftermarket catalytic converters must be EPA certified, and your car must have a gas conversion device of some manner. If not, both you and the installer are punishable of a Federal Offense by Section 205 (a). The operator's fine can be no more than $2,500 and the installation agency no more than $25,000.

So yeah your "freedom" is only because there is no $$ to enforce the laws on the books.

edeekeos 11-14-2014 04:10 AM
Quote:
Originally Posted by Maverickgear (Post 2021496)
I love your setup! Sounds really great! What's contributing to the popping sound though?
Thanks! I'll try to get some better vids up, I have a t3i I can try to use.

The popping is artificially enduced so to speak. I just edited my tune file with some negative timing at the lowest engine load. There a whole thread on it somewhere in here. I don't have the tune now though, it makes the car jerky when your off and on the throttle. Sounds cool as shit though, really impresses people for some reason lol.

alexand3r 11-16-2014 11:04 AM
Thread: http://www.ft86club.com/forums/showthread.php?t=62706

JDL Catless UEL Header
JDL Overpipe
Magnaflow #12265 Muffler

[ame="https://www.youtube.com/watch?v=OA2_vNCtwSE"]FRS JDL UEL, Overpipe & Custom Exhaust - YouTube[/ame]

D_Thissen 02-13-2015 09:19 PM
Bumpity.
Anyone have a UEL (Tomei/JDL/Revworks/OFH) paired with a cat-less front pipe and a Q300 (or similar) exhaust?

Xinshadow 02-16-2015 08:20 PM
Quote:
Originally Posted by D_Thissen (Post 2131783)
Bumpity.
Anyone have a UEL (Tomei/JDL/Revworks/OFH) paid with a cat-less front pipe and a Q300 (or similar) exhaust?
I have an OFH with nameless catted (not resonated) OP/DP combo and the perrin 2.5 CB. If you'd like a sound clip I can dig out my gopro and try to get some in-cabin driving around in the next couple days. I don't have a micover yet so I can't do external vids- so much wind noise you can't hear jack haha

Also, running (Mostly) catless, will still pass emissions just fine in IL, bags of douche or not, to whoever was concerned about emissions.

D_Thissen 02-16-2015 08:43 PM
Quote:
Originally Posted by Xinshadow (Post 2134916)
I have an OFH with nameless catted (not resonated) OP/DP combo and the perrin 2.5 CB. If you'd like a sound clip I can dig out my gopro and try to get some in-cabin driving around in the next couple days. I don't have a micover yet so I can't do external vids- so much wind noise you can't hear jack haha

Also, running (Mostly) catless, will still pass emissions just fine in IL, bags of douche or not, to whoever was concerned about emissions.
If you wouldn't mind that would be awesome. The Perrin 2.5 CB is pretty close to the Q300. A cold start video, a couple drive bys etc. would be great. Just trying to judge if it would be raspy that's all.


Thank you kindly!

Xinshadow 02-18-2015 06:36 PM
Quote:
Originally Posted by D_Thissen (Post 2134939)
If you wouldn't mind that would be awesome. The Perrin 2.5 CB is pretty close to the Q300. A cold start video, a couple drive bys etc. would be great. Just trying to judge if it would be raspy that's all.


Thank you kindly!
No problem! I was going to take some video today but its so cold here (-2F) my gopro suction mount won't stay on, so once we get back up into 30F or so I'll get some vids in.

scarfo 02-19-2015 03:57 AM
Header+front/overpipe(stock catback) enter yours
 
I'm running an open flash header with an mx-performance( Aussie brand) over pipe and invidia catted front pipe( all 2.5")

current stock CBE

Having a 2.5 inch MXP ( USA) exhaust fitted next week though.


Cold start the rear of the CBE rattles a little until it warms up then smooth sailing

Brzerker 02-19-2015 01:46 PM
Quote:
Originally Posted by edeekeos (Post 2022049)
Thanks! I'll try to get some better vids up, I have a t3i I can try to use.

The popping is artificially enduced so to speak. I just edited my tune file with some negative timing at the lowest engine load. There a whole thread on it somewhere in here. I don't have the tune now though, it makes the car jerky when your off and on the throttle. Sounds cool as shit though, really impresses people for some reason lol.
hi there again!

I'm currently in the market now searching for a catted front pipe to pair with my tomei UEL and stock cat back. I was wondering if you could share more about your CNT front pipe. Mainly on the fitment, how is it?

Thanks!

edeekeos 02-19-2015 02:11 PM
Quote:
Originally Posted by Brzerker (Post 2139051)
hi there again!

I'm currently in the market now searching for a catted front pipe to pair with my tomei UEL and stock cat back. I was wondering if you could share more about your CNT front pipe. Mainly on the fitment, how is it?

Thanks!
Fitment was absolutely perfect, everything lined up, and it came with all hardware and gaskets. I can't recommend it enough! I plan on buying their catted version in the near future to help cut out some of the rasp though.

benlaz88 02-19-2015 03:06 PM
Here are my setup. Sound are good, not too loud. Had some good compliment on it.

JDL Header
JDL Overpipe
Motiv Test Pipe
Perrin 2.5 resonated catback
AEM intake
OFT custom tune

M23 02-19-2015 03:38 PM
It's funny whenever there's a thread asking for, or about, stock oem catback exhausts..people can't help but post their aftermarket exhaust.


All times are GMT -4. The time now is 04:40 AM.
Page 4 of 6 123 4 56
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.


Garage vBulletin Plugins by Drive Thru Online, Inc.