Borla Header Instalation
 

Hi im new to this forum. Let me introduce myself. Im Eva owner of a 2013 scion frs and i live in Quebec Canada. Im a boat diesel mechanic. My question here is do i need a specific tool to remove any heat sensor on the header ? And if this header come with gasket or i need to buy them separatly. And if i need to remap my computer after the instalation ? Oh and if you guys have a great site where i can buy Borla UEL header without high shipping price for canada that would be great :wub: Sorry for my bad english this is not my primary language :P

hey, tu devrais oublier borla pis acheter le Open flash header et la tablette.
http://www.openflashtablet.com/
ta besoin d'un tune ou flash si tu veus quand tu installe des headers sinon tu aura un check engine et aussi yaura pas beaucoup de gain sans tune.

arigato!!!

Here's a DIY:

http://www.ft86club.com/forums/showp...67&postcount=3

On that page he says to use an O2 sensor wrench, but you can actually just use an open ended wrench instead.

And here's a full thread talking about the UEL header:

http://www.ft86club.com/forums/showthread.php?t=32101

FYI, there's a whole DIY forum at the bottom of the tech section. Many things you want to know about this car will be shown there. When you get ready for your next mod, search there for instructions.

Just today I replaced my tail lights, and there was a handy DIY that showed me pictures of exactly how to do it and what tools I would need before I started taking things off the car. A while back a DIY thread prevented me from breaking the plastic panels under the knee rests, because I would never have expected them to come off the way they do and would have snapped them in two if I hadn't seen detailed instructions.

I love the Borla UEL I have. It does not come with gaskets. I got mine for about $677.00 Canadian from Grounded Conceptz.